Xerox DocuPrint M750 User manual

USB Connection (Windows Millennium)
Step 1
Make sure the USB cable is not plugged into your printer's USB port yet.
Turn on your PC and start Windows. Wait for Windows to finish loading before
going to the next step.
(Note: The USB port install for the M750 or M760 is separate from the printer
driver install. The printer driver install should begin automatically following
Step 4 of the USB install.)
Step 2
Plug the USB cable into the printer’s USB port.
Windows should automatically detect your printer and start the Add New Hardware
Wizard.
Insert the DocuPrint M750 or M760 install disk in your CDROM drive.
(Note: If the M750 or M760 printer driver install program should begin during
USB installation then click Cancel then click Exit Setup on the printer driver
setup screen.
Add New Hardware Wizard will automatically advance to the next screen & read the
contents of the CDROM.

Step 3
Scroll down to the selection named USB\X750USB.INF (or X760USB.INF when installing M760) and
click on it
Click OK.
The Add New Hardware Wizard will install the USB driver.

Step 4
Click Finish
The USB port for M750 or M760 is now setup on your computer.
The M750 or M760 printer driver installer program should begin momentarily. If it does not start then
click Start > Run > D:\Setup.exe. (Note that the drive assignment of the CDROM drive may be
different on you computer.)
Was there a problem installing USB?
◆If the Add New Hardware Wizard does not start up after plugging the USB cable into your printer
then check that your cable is good and that USB is enabled on your computer (call your computer
manufacturer).
◆If the Add New Hardware Wizard screens went away prior to completetion of USB install then
remove then re-insert the USB cable in your printer.
◆We want to help you sucessfully install your printer so visit our web site or call our toll free
customer support hotline.
Was there a problem selecting the USB port while installing the printer driver?
◆Finish installing the printer driver to LPT1. Then go to Start > Settings > Printers and right click
on DocuPrint M750 (or M760) and click on Properties. Select the Details tab and then select
X750_USB0 (or X760_USB0 for M760) under Print to the following port. Select OK. You should
now be able to print to your printer’s USB port.