Xiaomi Mop 2 Pro User manual

Mi Robot Vacuum-Mop 2 Pro User Manual

Safety Instructions
Usage Restrictions
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
• The appliance is only to be used with the power supply unit provided with the
appliance.
• This appliance contains baeries that are only replaceable by skilled persons.
• Please keep the cleaning brush out of reach of children.
• Keep hair, loose clothing, fingers, and all parts of body away from openings and
moving parts.
• Do not use the vacuum-mop to clean any burning substances.
• Do not pick up the vacuum-mop by its laser radar cover.
• Make sure the vacuum-mop is turned off and the charging dock is unplugged
Read this manual carefully before use, and retain it for future reference.
This product is for floor cleaning in a home environment only. Do not use it
outdoors, on non-floor surfaces, or in a commercial or industrial seing.
01

before cleaning or performing maintenance.
• This vacuum-mop is only intended to clean floors in a home environment. Please
do not use it outdoors such as on an open balcony or on a surface that is not a
floor like a sofa, or in a commercial or industrial seing.
• Do not use the vacuum-mop in an area suspended above ground level, such as a
lo , open balcony, or on top of furniture, unless a protective barrier is present.
• Do not use the vacuum-mop at an ambient temperature above 35°C or below
0°C or on a floor with liquids or sticky substances.
• Pick up any cables from the floor before using the vacuum-mop to prevent it
from dragging them while cleaning.
• Pick up any fragile or loose items from the floor, such as vases or plastic bags, to
prevent the vacuum-mop from being obstructed or bumping into them and
causing damage.
• Do not place children, pets, or any item on top of the vacuum-mop while it is
stationary or moving.
• Do not use the vacuum-mop to clean the carpet.
• Do not allow the vacuum-mop to pick up hard or sharp objects such as building
materials, glass, or nails.
• Do not spray any liquid into the vacuum-mop (make sure the dust compartment
is thoroughly dry before its reinstalling).
• Do not place the vacuum-mop upside down (laser radar housing should never
touch the ground).
02

Baeries and Charging
• WARNING: Do not use any third-party baery. Use only with CDZ1SHW charging
dock.
• Do not aempt to disassemble, repair, or modify the baery or charging dock on
your own.
• Do not place the charging dock near a heat source.
• Do not use a wet cloth or wet hands to wipe or clean the dock’s charging
contacts.
• If the vacuum-mop won’t be used for an extended period, fully charge it, then
turn it off and store in a cool, dry place. Recharge the vacuum-mop at least once
every 3 months to avoid over-discharging the baery.
• The lithium-on baery pack contains substances that are hazardous to the
environment. Before disposing of the vacuum-mop, please first remove the
• Only use this product as directed in the user manual. Users are responsible for
any loss or damage arising from improper use of this product.
• This product's laser radar meets the IEC 60825-1:2014 Standard for Class 1 laser
product safety and does not produce laser radiation hazardous to the human
body.
03

Hereby, Xiaomi Communications Co., Ltd. declares that the radio equipment type
MJST1SHW is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
hp://www.mi.com/global/service/support/declaration.html
For detailed e-manual, please go to www.mi.com/global/service/userguide
baery pack, then discard, or recycle it in accordance with local laws and
regulations of the country or region it is uesd in.
• When removing the baeries from the product, it is beer to use up the
baeries and make sure your product is disconnected from power. Uninstall the
screw on the boom, then remove the cover.
• Unplug the baery connector, then remove the baeries. Do not damage the
baery case to avoid any risk of injuries.
• Return the baeries to a professional recycling organization.
04

Other Accessories
Cleaning Tool
Vacuum-Mop
Brush Brush Cover Side Brush
Accessories List
Pre-installed Accessories
Dust Compartment
Product Overview
Power CordCharging Dock
Note: Illustrations of product, accessories,
and user interface in the user manual are
for reference purposes only. Actual
product and functions may vary due to
product enhancements.
Water Tank (Mop pad installed,
for vacuuming & mopping mode)
Mop Pad
(Replacement)
Side Brush
(Replacement)
05

Edge Infrared Sensor
Collision Sensor
Power Buon
Dock Buon
Indicator
Cover
Charging Contacts
Laser Radar
(Laser Distance Sensor)
Indicator Status
Brush
Caster Wheel
Le Wheel/Right Wheel
Cliff Sensors
Side Brush
Brush Cover
Power Buon
Dock Buon
Yellow Wi-Fi not connected
Breathing white Updating firmware/Charging (baery level ≥ 15%)
Blinking white Returning to the dock to charge
White Turned on/Working normally/Fully charged/Wi-Fi connected/Downloading firmware
Blinking yellow Low baery/Error/Awaiting Wi-Fi connection
Breathing yellow Charging (baery level < 15%)
Docking Sensor
Turn on/off: Press and hold for 3 seconds
Start/Pause: Press
Pause: Press when it is working
Start docking: Press when it is paused
Stop docking: Press when it is docking
06

Dust Compartment Release Buon
Dust Compartment Cover
Filter
Water Tank Release Buon
Water Tank Lid
Dust CompartmentVacuum-Mop
Water Tank (Used for Vacuuming & Mopping Mode)
Charging Dock (Place against a Wall)
Wi-Fi Indicator
Reset Buon
Staying blue for 2 seconds then
goes off: Wi-Fi connected
Blinking blue: Connecting to
Wi-Fi/Updating firmware
Blinking yellow: Awaiting Wi-Fi
connection
Press and hold for 3 seconds to
reset the system.
Press and hold for 10 seconds to
restore the system.
Signaling Area
Note: The water tank may contain a small amount of residual water due to quality
inspection. This is normal.
Note: The dust compartment must be installed for both vacuuming mode and
vacuuming & mopping mode, otherwise the vacuum-mop cannot be turned on.
Power Port
Charging Contacts
Water Filling Opening
Electrode Plate
07

Removing the protective strips
Installation
Charging
> 0.5 meters
> 1.5 meters > 0.5 meters
Placing the charging dock against a wall and connecting it to an
electrical outlet
Note:
• Do not place the charging dock in an area with direct sunlight.
• Make sure there are more than 1.5 meters of clearance in front of the charging dock
and more than 0.5 meters on either side of it.
• Tidy up any loose power cord to prevent the vacuum-mop from geing tangled,
which could accidentally move or unplug the charging dock.
Note:
• If the vacuum-mop cannot be turned on due to a low baery, put it against the
charging dock to charge.
• The vacuum-mop will automatically turn on when it is on the charging dock, and
cannot be turned off while charging.
Before using the vacuum-mop, remove the protective strips from each side.
When using the vacuum-mop for the first time, manually place it against
the charging dock to charge. Ensure that the charging contacts on both
the vacuum-mop and the charging dock are aligned. During daily use, you
can directly press the buon to send the vacuum-mop to the charging
dock to charge.
08

Open from here
Water Tank
Mop Pad
Vacuuming mode (install dust compartment):
Open the cover of the vacuum-mop, and install the dust
compartment into the vacuum-mop until it locks into place.
Vacuuming & mopping mode (install dust compartment, water tank, and mop
pad):
1. Slide the mop pad along the slot of the water tank, and then aach the
pad firmly onto the velcro.
2. Open the water tank lid, fill the tank with water, and then reaach the lid.
It is strictly forbidden to immerse the water tank into water.
CAUTION:
• Do not rinse the water tank or immerse it in water. To avoid corrosion and damage, do
not use any detergent, disinfectant, solid cleaner, or other cleaning products on the
water tank.
• Do not add hot water to the water tank, as this may cause it to become deformed.
Velcro
Velcro
Installing accessories for the desired mode
Note: Regularly cleaning the dust compartment can prevent dirt from building up.
Otherwise, the performance of the vacuum-mop may be reduced.
09