XVTEC XVC-ULTRA User manual

Product overview
Check kit contents
Power & connect
Connect the video source to the
encoder (optional).
1
1
1
2
2
5
3
3
6
4
4
Follow the instructions in this guide in order to quickly prepare your XVC-ULTRA encoder for operation.
NOTE: For additional information refer to the XVC-ULTRA Encoder User’s Guide.
FRONT
XVC-Ultra encoder
Power supply
Four rubber feet pads
Warranty + EULA
2Connect the host PC to the ETH port using a
LAN cable - either directly, or via a network
switch.
QUICK INSTALLATION GUIDE
STAT
ACT
LCK
PWR
HDMI IN
LINE IN
SW
ETH RS-232/485 USB
12V DC
STAT
ACT
LCK
PWR
HDMI IN
LINE IN
SW
ETH RS-232/485 USB
12V DC
1
2
3
4
5 6 7
1 2 3 4
STAT – Status LED
ACT – Streaming activity LED
LCK – Video lock indicator LED
PWR – Power LED indicator
HDMI IN - HDMI v2.0 video input
SW – General switch
LINE IN - Analog audio input
(unbalanced, genlocked)
7
Ethernet port
RS-232/RS-485 port
USB – USB 2.0/3.0 host port
12VDC - Input voltage
STAT
ACT
LCK
PWR
HDMI IN
LINE IN
SW
ETH RS-232/485 USB
12V DC
STAT
ACT
LCK
PWR
HDMI IN
LINE IN
SW
ETH RS-232/485 USB
12V DC
REAR

4Download and install the XVTEC managment
tool from:
https://www.xvtec.com/support/downloads
on a Windows-based OS.
Refer to the user guide for the next steps.
Download the user guide from:
10
To access and congure the XVC-ULTRA
using the web-based user interface, enter the
IP address of the encoder unit in the address
bar of the browser.
7
The main page of the Conguration System
appears in the browser window.
9
Sign in by entering your user name and
password in the dialog box displayed by your
browser. A sample dialog box appears in the
gure below.
The default credentials are:
Username: admin
Password: admin
8
Execute the XVTEC Management Tool . The
application discovers the devices in your
network, and displays them as a list.
You may need to disable Windows Firewall to
enable discovery.
5
Find the row in the table associated with
your encoder. Right-click on the row, and
select "Set IP". The Set Device IP dialog box
appears.
Select "Static" or "DHCP" IP conguration.
If “Static” is selected, enter the encoder’s IP
Address, Subnet Mask, and Default Gateway
settings. Click Apply to save the new settings.
6
Power on the system by connecting the
power supply to the input power connector
(Note, the power supply is provided with a
locking connector).
3
STAT
ACT
LCK
PWR
HDMI IN
LINE IN
SW
ETH RS-232/485 USB
12V DC
https://xvtec.com/wp-content/downloads/XVC_Ultra_
HDMI_Encoder/XVC-ULTRA-User-Guide.pdf
V1