Xylem ebro EBI 300 User manual

Single Use USB Data Logger
EBI 330-T30 / EBI 330-T85
User Manual

User manual EBI 330 V 1.1 Page 2 / 16
Table of contents
Overview ................................................................................................... 3
Safety instructions .................................................................................... 5
Unpacking / Package Contents ................................................................. 6
Configuration ............................................................................................ 7
Start / Stop ................................................................................................ 8
LEDs........................................................................................................... 9
PDF .......................................................................................................... 10
Battery..................................................................................................... 11
Cleaning and maintenance...................................................................... 11
Disposal ................................................................................................... 11
Technical Data......................................................................................... 12
Approvals ................................................................................................ 14

User manual EBI 330 V 1.1 Page 3 / 16
Overview
EBI 300 series data logger is a battery powered temperature
measurement and recording instrument for monitoring
temperature sensitive products during transportation. They
can be programmed indefinitely, but as soon as the
measurement is running, they can´t be restarted.
The logger has a USB-interface for connecting directly to a
computer or USB-printer.
When connecting the logger to a USB-port a PDF file with a
chart of all recorded measurement values and the alarm
status (limit violations) will be automatically generated. The
PDF file can be opened, printed or archived without any
other additional software.
The USB connection can also be used to read out and
program the logger with the softwares
Winlog.pro/.light/.basic. You can program the devices via the
free website http://www.ebi330.de as well, or order them pre-
configured.
There are two versions: for regular deep temperature
applications down to -30°C / -22°F the EBI 330-T30 with
black protective cap, and for dry ice applications the EBI 330-
T85 with blue protective cap. The following is referring to
both versions, except for the technical data.

User manual EBI 330 V 1.1 Page 4 / 16
1
2
3
1............. Eye
2............. LED
3............. Start/Stop button
4............. USB-connector
5............. Protective cap
4
5

User manual EBI 330 V 1.1 Page 5 / 16
Safety instructions
Do not use the device in explosive areas.
Danger of death!
Do not use the device in an environment hotter than
60°C! The lithium battery may explode!
Do not expose the unit to microwave radiation. The
lithium battery may explode!
To ensure the logger is water tight, the protective cap
must be fit or an external probe must be connected.

User manual EBI 330 V 1.1 Page 6 / 16
Unpacking / Package Contents
After receipt of delivery, please check the equipment for
any damage. Furthermore, please verify that the delivery
corresponds to your order.
Scope of Delivery
The delivery includes:
x10 EBI 330 temperature data loggers, each with
battery, protective cap and a label, on which the
device type, serial number, bar code and
temperature limits are printed.
Should you have a complaint for any reason, please do
not hesitate to contact us:
ebro Electronic GmbH
Peringerstraße 10 D-85055 Ingolstadt
Tel. [phone]
Fax. [phone]
Internet: www.ebro.com
eMail: [e-mail]

User manual EBI 330 V 1.1 Page 7 / 16
Configuration
The loggers can be ordered preconfigured. As long as the
measurement hasn´t started yet, it is possible to reconfigure
it any time. The configuration options are, among others:
xMeasurement interval
xUpper temperature limit
xLower temperature limit
xAlarm delay
xStart delay
xTime zone
xLanguage of the PDF-file
You can apply these settings by downloading the free of
charge software Winlog.basic from http://www.ebi330.com
and using the software to program the device. Please refer to
its user manual.
Naturally, the loggers are supported by the proprietary
softwares Winlog.light and Winlog.pro as well, enabling the
user to benefit from the advanced options of these programs.
Lastly, the website itself has an online configurator, with
which you can program the devices, too. Therefore a
software installation is not required.

User manual EBI 330 V 1.1 Page 8 / 16
Start / Stop
The logger is started by pushing the start/stop-button for at
least three seconds.
CAUTION! The device can only be started once!
Depending on the set start delay, the device starts to
measure immediately or after a few minutes. It will continue
to measure and store temperature data according to the set
interval, until the data memory is full (up to 6000 values), the
battery empty (lasts for at least 100 days), or the device is
being stopped.
To stop the logger, again push the button for at least three
seconds. Alternatively, remove the protective cap and plug
the device into a USB-slot of your PC, laptop or USB-printer.
The logger will be stopped and the PDF-file generated
automatically.
CAUTION! After the logger is being stopped, it can´t be
restarted!

User manual EBI 330 V 1.1 Page 9 / 16
LEDs
The logger has a green and a red LED.
When pushing the start/stop button, the LED will flash as
long as you keep the button pushed - red for start, green for
stop. Start and stop, respectively, are confirmed by triple
blinking of the LED.
As soon as the logger is started, the green LED will blink
every five seconds. This will continue until the logger is being
stopped, the battery is empty, or a temperature limit has
been violated.
Should any of temperature limits be violated for longer than
the configured alarm delay, the logger will blink red instead of
green every five seconds. This will continue until the logger is
being stopped or the battery is empty.
When the logger is being stopped, the LED will double blink
every five seconds –green, if no limit has been violated,
otherwise red.

User manual EBI 330 V 1.1 Page 10 / 16
PDF
As soon as the logger is plugged into a USB-slot, it
automatically creates a PDF-file, which is saved on a USB-
drive, similar to the ones of USB-sticks. The file can easily be
copied from there.
The file has a lot of information to the measurement –the
logger configuration, statistic data to and a chart of the
measurement, and possible alarms. Thus, all relevant data
can be viewed in one glance.
To display the PDF-file, a PDF-reader software is required. It
is not included in the delivery.

User manual EBI 330 V 1.1 Page 11 / 16
Battery
The battery of the EBI 330-T30 loggers lasts for at least 100
days, independently from application temperature and the
measurement interval.
The battery of the EBI 330-T85 loggers lasts for at least 100
days.
In neither logger version you can replace the battery.
Cleaning and maintenance
Please use a damp cloth to clean the logger.
Do not use a solvent, such as acetone, in order to avoid
corrosion of the plastic.
Disposal
If the device will no longer be used, please dispose of
the device in a suitable and environmental-friendly
manner.

User manual EBI 330 V 1.1 Page 12 / 16
Technical Data
General
Accuracy class: 1
Resolution: 0.1° C
IP rating: IP 65
Norms: DIN EN 12830 (S, T, C, D, 1), ATP
Calibration: batch calibration
Size: 80 x 28 x 12 mm
Weight: 16 g (incl. battery)
EBI 330-T30
Temperature: -30 °C…+60 °C / -22 °F…+140 °F
Accuracy: ± 0.5 °C (-20 °C … +40 °C)
± 0.8° C for the remaining range
Operating temp.: -30 °C … +60 °C (-22 °F … +140 °F)
Storage temperature: -40 °C … +85 °C (-40 °F … +185 °F)
Power supply: Lithium-cell (CR2032), 3V

User manual EBI 330 V 1.1 Page 13 / 16
EBI 330-T85
Temperature: -85 °C … +50 °C / -121 °F … +122 °F
Accuracy: ± 2.0 °C (-85 °C … -30 °C)
± 0.8° C (-30 °C … -20 °C)
± 0.5° C (-20 °C … +50 °C)
Operating temp.: -85 °C … +50 °C / -121 °F … +122 °F
Storage temperature: -40 °C … +85 °C / -40 °F … +185 °F
Power supply: Lithium-cell (TLH-2450), 3,6V

User manual EBI 330 V 1.1 Page 14 / 16
Approvals
The conformity certificate confirms that this product complies
to CE guidelines 2004/108 EG.
The product EBI 330 complies to the guidelines in
accordance with EN 12830.
Suitability:
S (Storage), T (Transport)
Location:
C (Food storage and distribution systems), D (Food
Transport Vehicles)
Accuracy classification:
1, for measurement of the air temperature

User manual EBI 330 V 1.1 Page 15 / 16