Yealink CTP18 User manual

www.yealink.com
Quick Start Guide (V1.0)
English | 简体中文
CTP18
Collaboration Touch Panel

1
CTP18 Connection
Connect your CTP18
Reset
MAC
SN
VC200
PoE
B
or
Video Conferencing Endpoint（except VC200)
Note:
The CTP18 supports 48V/0.27A PoE supply.
Make sure of the connectivity between the CTP18 and endpoint. Otherwise, the
CTP18 may not work properly.
You can also connect the CTP18 to the VCM34, and then connect to the power
and wired network.
If the VC Hub/Phone port of the endpoint is used, you can connect the CTP18
to the PoE switch for power supply and connect to the wireless access point
provided by the endpoint.
A

2
CTP18 Installation
Put on a table
You can place the system on the conference room table and adjust the touch
screen as you need.
28°
50°
Assemble your CTP18
Reset
MAC
SN
1
2
34
Reset
MAC
SN
VCH

3
Start to Use the CTP18
After connected to the power and network, the CTP18 starts automatically.
The CTP18 synchronizes the configurations from the endpoint and goes to
the Home page. From the Home page, you can configure the ndpoint via
the CTP18. For more information, refer to the user guide.
Mount on a Wall
1
33
100mm
If the conference room environment allows, you can also route the CTP18
through the wall.
4
22
55
6