Yellobrik OBD 1410 User manual

TX
RX
Power
yellobrik Quick
Reference
OBD 1410 (pair)
12Gbit Bidirectional SDI/Fiber Transceiver
Transmitting
Data
LYNXTechnik AG www.lynx-technik.com
Power
Connected
WARNING
LASER RADIATION
Do not view directly with
optical instruments
CLASS 1M LASER PRODUCT
Receiving
Data
We are constantly adding additional yellobrik modules.
Please visit our website for the latest product updates.
www.lynx-technik.com
®
Technical Specifications
SDI Video 1 x SDI video input
1 x SDI Video output
75 Ohm BNC connectors
SMPTE 2082-1, SMPTE 2081-1, SMPTE 424M, SMPTE 292M
Multi-standard operation from 270Mbit/s to 12Gbit/s
Multi-rate reclocking
270Mbit/s - 1.48Gbit/s - 3Gbit/s - 12Gbit/s
Return Loss: > 15dB to 1.5GHz and > 10dB up to 3GHz
Automatic cable EQ (Belden 1694A cable)
250m @ 270Mbit/s, 140m @ 1.5Gbit/s, 80m @ 3Gbit/s
Fiber Optic 1 x Bidirectional fiber connection (LC/PC Connection)
SMPTE 297M - 2006
1270nm and 1330nm (WDM)
TX and RX active LEDs on side of module
Max. distance 10km (6.2 miles) @ 12Gbit/s (single mode)
Power +12VDC power supply (included)
Power LED on side of module
yellobrik
®
LYNXTechnikAG
0V
+12V d.c.
RX/TX
WARNING
CLASS 1
Laser Product
Connect
to TYPE B TYPE A
LYNXTechnikAG
0V
+12V d.c.
RX/TX
WARNING
CLASS 1
Laser Product
Connect
to TYPE B TYPE A
LC Fiber Optic
Input / Output
SDI Video
Input
DC Power Input
SDI Video
Output

Connections
The SDI video input and output is connected to the corresponding 75
made to the LC connector as indicated on the module. An example of a
LC connector shown below.
Operation
The OBD 1410 is a bidirectional transceiver which can send and receive
supplied as pairs, one “Type A” and one “Type B” and must be used as a
pair. This is a closed loop WDM application using 1270 and 1330nm
wavelengths.
ed and received. Operation is
automatic, no user settings are required. For transmission, the SDI
video format is automatically detected, re-clocked and then
detected automatically, re-clocked and output as an electrical SDI
signal.
The OBD 1410 supports any SDI video signal from 270Mbit/s to 12Gbit/s.
Max distance is approx. 10km (6.2 miles). Data send and receive activity
is indicated by the LEDs located on the side of the module. The module
supports hot swapping and hot plugging of connections.
Power
The module requires a 12V DC power input and a LED is provided to
applying your own power, please provide a clean 12V DC power source.
Module power consumption is approx 250mA (2.8VA)
Power Lead Strain Relief
The module has a small hole in the case located above the power
connection to prevent the power lead being accidentally pulled out.
Use the supplied tie-wrap and secure the lead as shown below.
Note:                                                         
Optional Mounting Bracket
The optional RFR 1001 mounting bracket can be used to permanently
Ohm BNC connections provided (up to 12Gbit). The ber connection is