tested
Germany
EMC
R
OPERATION
www.yli.cn We create security
1.Enter Program Mode
Press # # # # (Red LED: Off, Green LED: On) 123456 # (If Success, Red LED: Off, Green
LED: Twinkle)
Remark: 123456 is the original Program Code
2.Modify Program Code
Press 0 New Program Code # New Program Code #
Remark: New Program Code must be 6 digits
3.Register Cards Continuously, Submit Card No. Automatically
Press 1 Read Card (Read Unregistered Card Continuously) #
Remark:
A: The system will keep record each card, then distribute Card NO. & Code (888888) automatically,
This Code (888888) is used in Card + Code Operation Mode condition, can't be use to open door sep-
arately." how to modify and use, will be explain in the following".
B: If there is no card record in system, means the first card NO. that user read is 0001, the second Numbe r
That user read is 0002, etc. But the max card NO .is not more than 2000.
C: If there are no card records, card NO. will be superimposed when read unregistered card. Such as,
the system keeps the record is 0260, and now, user read new unregistered card, the n this Card NO. is 0261.
D: If the Card (registered card) is exist, when user read it again, the buzzer will sound.
4.(1)Register 1 Card, Setting Card No. Manually
Remark:
A: If the Card (registered card) is exist, when user read it again, the buzzer will sound.
B: If the Code NO. is exist, when user enter it again, the buzzer will sound.
(2)Register Cards Continuously, Setting Card No. Manually
Register 1 Card, Setting Card No. Manually: Press 2 Read Card (Read 1 Unregistered Card)
+Card NO.(Setting by user)+ # #
Register Cards Continuously, Setting Card No. Manually: Press 2 ReadCard (Read Unregis-
tered Card) +Card NO. (Setti ng by user )+ # , Read Card (Read Unregistered Card) +CardNO.(Setting
by user)+ # ,...... #
5.Delete Card and Card Number
Delete Card: Press 30 Read Card # (User can delete Card Continuously)
Delete Card NO.: Press 31 Enter Card NO. + # # (User can delete Card NO. Continuously)
Delete Card NO.: Press 32 9999 # (User can delete all Cards and Card NO.)
6.Setting Operation Mode
1) Press 40 # (Card or Code Operation Mode, this is Default Setting when produce)
2) Press 41 # (Card + Code Operation Mode)
3) Press 42 # (Code Operation Mode)
7.Setting Time
Press 5 (time) #
For example:
Press 5 03 # , means the time setting is 3 sec
Press 5 22 # , means the time setting is 22 sec
Remark: Under can set 01-99 sec, the opening method of relay is touch (Read Card to Open, Read Card
to Close).
8.Setting Code (Default is blank when produce)
1) Press 6 New Code + # New Code+ # (Code is 4--6 digits)
2) Press 6 # # (User can't use code to open the door) P2
