Yoshimura DH35-45-PW User manual

www.yoshimuracycling.com
DH Stem Kit
5420 DANIELS STREET STE A, CHINO CA., 91710 · [phone] · [phone] · FAX [phone]
Part # Description
DH35-45-PW 45mm Stem Kit, Pewter
DH35-50-PW 50mm Stem Kit, Pewter
DH35-55-PW 55mm Stem Kit, Pewter
DH35-45-YK 45mm Stem Kit, Yoshikote
DH35-50-YK 50mm Stem Kit, Yoshikote
DH35-55-YK 55mm Stem Kit, Yoshikote
Always wear a helmet and follow trail etiquette when riding.
WARNING
Proper installation and use of this stem in accordance with the
manual are essential for the safety of all users.
Parents/Guardians must ensure that the correct procedures for
installation and use of this product are followed and understood by
the minor.
Misuse or failure to follow the specified installation instructions and
heed warnings may result in injury or death. In the event of a crash inspect for wear, damage, or loose
components.
Periodically clean dirt & debris off stem.
Contact Yoshimura Tech Department at [phone] / in CA
[phone] or visit www.yoshimuracycling.com.
All Yoshimura stem kits carry a one-year limited warranty against
defect in workmanship and/or materials and is only provided to the
original purchaser. Original receipt or invoice will be required for
processing.
Damages caused by abuse, misuse, lack of service, improper
installation and/or modifications are not covered under this warranty
and are specifically disclaimed.
For more warranty information, please visit
www.yoshimuracycling.com.
WARNINGS TO USERS & PARENTS / GUARDIANS
WARRANTY
CARE & MAINTENANCE
Stem kit is pre-assembled out of the box with all
bolts hand-tight.
Remove all bolts and apply grease to threads
when installing.
READ THIS MANUAL BEFORE
INSTALLING STEM KIT
! !
!
Single Crown Reach
DH Direct Mount Reach

5. Torque the four clamp base bolts to 10 Nm.
Note: There should be no gaps between clamp base and
upper clamp as shown.
6. Torque the two forward clamp bolts to 5 Nm.
7. Check to make sure all components are secure prior to
riding.
2
Installation
1. Clean handlebar.
2. Grease 6mm x 16mm bolts and install clamp base directly
to front fork. Do not torque at this time.
3. Grease 6mm x 35mm bolts and install handlebar and
upper clamps. Do not torque at this time.
4. Grease 5mm x 12mm bolts and hand tight forward clamp
bolts to desired handlebar alignment. Do not torque at this
time. Leave minimum 2mm gap as shown.
Left Right
M6X35TP
M6X16TP
M5X12TP
Leave at least
2mm gap