YUNEEC MantisQ User manual

Quick Start Guide V1.0

01 Propellers
02 Power Button
03 Battery
04 Battery Lock
05 USBType-C
06 Micro SD Card Slot
07 Camera
01 Phone Holder
02 Control Sticks
03 Power Button
04 Photo Button
05 Standard USB Port
06 USBType-C
07 Video Recording Button
Aircraft
02
01
03
04
Controller
Product Name: Mantis Q Remote Controller
Model: YUNMQRC
Product Overview
Product Name: Mantis Q
Model: YUNMQA
01
02
03
04 05 06 07
070605

• Download Yuneec Pilot App.
Mantis Q supports iOS 9.0
(or later) or Android 5.0 (or later).
2.Preparing the Aircraft
• All arms and propellers must be unfolded before powering on.
•To fold the Mantis Q, reverse the unfolding instructions.
3.Charging the Flight Battery
• Charge the flight battery to “Solid Green”,
approx. 1.5 hours.
1.Charging the Remote Controller
• Use USBType-C (only for charging)
to charge, approx. 1 hour.
Remove the
camera protector
Unfold the front armsUnfold the rear arms
• Press the lock button and remove the flight
battery.
• Push the flight battery into the
aircraft until hearing a ‘click’ .
1
2
4.App Download
Before Flight

• LaunchYuneec Pilot App.
• Follow on screen directions to connect phone
or controller to the aircraft.
• For manual connection through WiFi,
the password is:1234567890.
Option 1
Tap the icon [ ] on the app and then slide to take off.
4.Take Off
3.Connecting to Mantis Q
2.Power On
1.Installing the Smart Device
First Flight Part 1
Pull out the
phone holder
Install the
smart phone
Connect the smart phone
with the remote controller
(Iphone and Android cable
not included)
Power on the Mantis Q Power on the controller Start the motors. Take off
To power on the Mantis Q and the remote controller, press
and hold the power button for two seconds until you hear
two rising tones.
Option 2
• Move the sticks for 1.5 seconds as shown below to
start the motors.
• Slowly raise Left Stick to take off.
•To ensure safe flight, step back approximately 9ft
(3m) behind the Mantis Q.

Option 1
Tap the icon [ ] on the app and then slide to land.
Option 2
Slowly lower Left Stick to land.
To land properly, ensure that
the aircraft is away from any
obstacles or obstructions as it
will land directly below where
it is hovering.
2.Landing1.Direction Control
Left Stick
Up
Down
Rotate
Left
Rotate
Right
Right Stick
Forward
Back
Left Right
3.Power Off
First Flight Part 2
•To power off the Mantis, press and hold the power
button for two seconds.
•To power off the controller, press and hold the
power button at the center of the controller for two
seconds.
*If you experienced a slight drift during your first
flight, it may be best to calibrate your compass.
Please go to the Settings section within your app
and follow the on-screen instructions to calibrate
the compass.
Move the control sticks as below to control the direction of the Mantis Q.

Any information might be changed due to the software update. For the latest documents, please check the official website：www.yuneec.com