ZIGBEE 624 User manual

LED624 RGB LED Bulb
Quick Start Guide

2
Introduction
1
The LED624 ZigBee RGB LED bulb allows you to switch it ON and OFF and
adjust its color as well as set a switching schedule by the mobile app.
This guide will provide you with an overview of the product and help you
get through the initial setup and installation.
Get started
2
3.1 To get started, you will need:
A ZigBee Gateway.
The mobile app.
3.2 Set-up the LED bulb
Step 1: Install and power on your LED624 LED Bulb, it will flash once to
indicate it is ready to join the gateway (reset it if not).
Step 2: Select “Add new devices” in the menu of the app.
Tip: for this step, you can also press the “Z” button of the gateway for two
seconds until the LED indicator turns solid blue.
Step 3: The LED Bulb will join the the gateway automatically, and flash once
when it has connected to the gateway. You may now use your phone to turn
ON/OFF the bulb, adjust the brightness and color.
Note: If the LED bulb failed to join the gateway, please refer to the FAQ
section to reset the bulb to factory default setting and retry above steps.

3
3FAQ
Q1. How can I reset this device to default factory settings?
A1: Turn on then turn off the bulb for ten times (off, on, off, on, off, on, off,
on, off, on, off, on, off, on, off, on, off, on, off, on) and the bulb will turn flash
several times and then become solid to indicate it has successfully restored
to the factory default setting.
Q2. Can I use a dimmer switch to control LED624 LED bulb rather than the
mobile app?
A2: Yes. Please see the SLC603 dimmer switch user guide.
4Technical Specifications
Operating Voltage • ZigBee 2.4GHz IEEE 802.15.4
RF Characteristics
• Operating frequency: 2.4GHz
• Range outdoor/indoor:
100m/30m
• Internal PCB antenna
Operating Wattage • 9 W
Lumen • 750 lm (60W equivalent)
Average Lifetime • 25000Hrs
Light Appearance • White and Color
Beam Angle • 270 wide
Dimensions • Height: 110 mm
• Diameter: 65 mm
Weight • 150 g

4
Safety Notice
WARNING: Failure to follow these safety notices could result in fire,
electric shock, other injuries, or damage to the LED bulb and other
property. Read all the safety notices below before using the LED bulb.
5
• Avoid high humidity or extreme temperatures.
• Avoid long exposure to direct sunlight or strong ultraviolet light.
• Do not drop or expose the unit to intense vibration.
• Do not disassemble or try to repair the unit yourself.
• Do not expose the unit or its accessories to flammable liquids, gases or
other explosives.