Reset the Remote Control
When you rst time use the remote control, please reset it and please follow the steps
as below:
•Insert the CR2032 battery.
**While doing this, please be very careful of the material on the PCB, strong push
might damage or break the components on PCB.
•After insert the battery, the Red LED will ash about 0.5 second.
•Please press Arm button 3 times, then Orange LED will ash 3 times.
•Press Panic button 3 times within 3 seconds, then the Orange LED ash 3 times,
after this, Red LED will ash once and turn off.
Join Controller
•Press either Arm or Night mode button, then LED ash fast.
•Press any key, Green LED ash 3 times means join successfully.
•Once it is joined successfully, the service control panel will also shows "ACE join OK".
•The remote control is not water-proved.
•Do not use or store in dusty or dirty areas. This will damage its electronic
components.
•Please avoid hot and cold areas. High and low temperatures would shorten
the life of electronic devices and damage battery.
•Do not use harsh chemicals, cleaning solvents, or strong detergents to clean it.
•Do not drop, knock, or shake the device. Rude handling can break internal
circuit boards and ne mechanics.
Attention
FAQ
Q:Remote control not working
A:
•Make sure if it is successfully joined the service control panel.
•Make sure if the battery is install properly.
•Press any key to make sure if the LED ash once.
•Make sure the control is within the operation range.