Zoom MULTISTOMP MS-100BT General instructions

MS-100BT v1.30 Firmware Update Guide
For Mac
Copyright(C) 2013 ZOOM Corporation. All Rights Reserved.
Ver. 1.30
Macintosh® and Mac OS® are trademarks or registered trademarks of Apple Inc. Other product names, registered
trademarks and company names are properties of their respective owners.
Bluetooth is registered trademarks of Bluetooth SIG, Inc. and are used under license by ZOOM Corporation.
Note: All trademarks and registered trademarks in this document are used only for identification. There is no intention
to infringe on the copyrights of their owners.
The explanatory illustrations in this manual might differ in appearance from screens on the
actual unit.
1. Supported operating systems
Mac OS X 10.5
Mac OS X 10.6
Mac OS X 10.7
Mac OS X 10.8
Before using this application:
1）Log in to your Mac using an account with administrator privileges.
2）Before launching this application, close all other running applications.
●ZOOM Corporation will bear no responsibility for losses or claims from third parties that result
from the use of this software. Moreover, without our permission, distributing, selling, leasing, renting,
altering and reverse engineering of this software are prohibited. Furthermore, the specifications of
this software and the contents of this document could be changed without notice in the future.

2
2. Introduction
Thank you for downloading the “ZOOM MS-100BT System v1.30 Updater” application.
This document explains how to update the MS-100BT firmware.
3. Checking the MS-100BT firmware versions
Following the procedures on page 25 of the MS-100BT operation manual, check the
firmware versions of your MS-100BT. If the SYSTEM version is v1.30 or higher, you do not
need to use this application to update the firmware. If the system version is lower than
v1.30, follow the procedures below to update the firmware.
4. Updating the firmware
Before updating the firmware, if any applications are running, quit them all.
4.1. Press parameter knob 1 on the MS-100BT to open the MENU.
4.2. Select Bluetooth in the MENU and select PAIRING. Then, use the computer to pair
the MS-100BT as a Bluetooth device.
NOTE
For this update, leave PAIRING selected.
NOTE
There is no need to pair in the Bluetooth pane of the Mac System Preferences.

3
4.3. Double-click the “ZOOM MS-100BT system v1.30 Updater” icon for the firmware
updating application to launch it.
After launching, a window that looks like this appears.
4.4. Click the “Bluetooth Device” field and select “ZOOM MS-100BT (number that
identifies the specific device)”.
4.5. Click the Execute button to start the firmware update. A progress bar shows the
status of the firmware update.
The firmware update execution screen appears on the MS-100BT display.
Do not interrupt the power to the MS-100BT while the firmware is being updated.
4.6. When the firmware update completes, the following will be shown. Quit the firmware
update application.

4
4.7. After “Complete!” appears on the MS-100BT’s display, turn it off. Turn the MS-100BT
on again and confirm that the SYSTEM version is now v1.30.
NOTE
If updating the firmware should fail for any reason, the MS-100BT will still be ready for a
firmware update when it is restarted. Updating the firmware at this time is also possible. In
this case, before conducting the firmware update again, open the Bluetooth pane in the
Mac System Preferences and delete the ZOOM MS-100BT.
This completes the firmware update.
Z2I-1864-02