Zotac ZBOX series User manual

QUICK START GUIDE
PACKAGE CONTENTS
CUSTOMIZING YOUR ZOTAC ZBOX
INSTALLING MEMORY MODULES
INSTALLING HARD DISKS
• 1 x ZOTAC ZBOX
• 1 x Stand
• 1 x AC Adapter
• 1 x Power Cord
• 1 x Warranty Card
• 1 x User Manual
• 1 x Driver disc
• 1 x Antenna
1. Lay the ZOTAC ZBOX on a flat surface with
the rubber feet facing upwards.
2. Locate the two thumb screws and remove.
3. Slide the cover o the ZOTAC ZBOX in the
direction of the arrow.
1. Locate the SO-DIMM memory slots
and insert a SO-DIMM memory
module into the slot at a 45 degree
angle.
2. Gently press down on the memory
module until it locks into place by
the arms of the memory slot.
1. Insert the hard disk bracket into
the SATA slot.
2. Reinstall the thumb screw.
1
2
3
1
1
2
2

SETTING UP YOUR ZOTAC ZBOX
FRONT PANEL
REAR PANEL
1. Select your ZOTAC ZBOX position
i. Place ZOTAC ZBOX sideways
ii. Install ZOTAC ZBOX on the stand
2. Connect antenna for WiFi
3. Connect DisplayPort display
4. Connect to home network
5. Connect an optical S/PDIF
output
6. Connect VGA display
7. Connect HDMI displays
8. Connect USB 3.0 devices
9. Connect power cable
10. Turn on the system
11. Install operating system
1. Headphone/Audio
Out jack
2. Microphone jack
3. USB 3.0 port /
Memory card reader
(SD/SDHC/SDXC)
4. USB 3.0 Type-C
5. WiFi LED
6. Hard drive LED
7. Power button
1. WiFi antenna
connector
2. DisplayPort
3. LAN (RJ45) port
4. Optical S/PDIF out
5. VGA port
6. HDMI port
7. USB 3.0 ports
8. Power input
(DC19V)
345 1 7
32 51 7 8
2
3
4
5
6
78
26
46
iii
1
9
10