Zte A004ZT User manual

1
A004ZT
Let’s Go
Getting started with your device.

2
1. Prepare
A valid nano-SIM card.
Open the back cover and view the label in the battery slot to
get the default information. The following figure is for
reference only.

3
2. Install the Battery
1. Open the back cover.
2. Insert the battery.

4
3. Put the cover back.
3. Insert the nano-SIM Card
1. Insert the tip of the tray eject tool into the hole.
2. Pull out the card trayand place the nano-SIM card on the tray,
as shown. Carefully slide the tray back into place.

5

6
4. Start Your Device
Press and hold the power button until the screen lights up and
then the device will connect to the Internet automatically.
NOTE:
If the battery is extremely low, you may be unable to power on
the device. Please charge your device first.

7
5. Access the Internet
Wi-Fi: The default Wi-Fi SSID and password can be found
on the device label. Connect to the Wi-Fi network with your
mobile device and then access the Internet.
NOTE:
You can touch the screen to view the default Wi-Fi SSID and
password.
USB Type-C cable: Connect with the computer via USB port
and then access the Internet.

8
Network cable: Connect with the computer via a network
cable and then access the Internet.

9
6. Change Your Device Settings
You can change the device settings by logging in to the 5G
Mobile Hotspot configuration web page.
1. View the label on your device to get the default Device
Manager Website IP address and Password.
2. Launch the Internet browser. Enter the Device Manager
Website IP address in the Address bar.
3. Input the Password and then click Login.
4. After the 5G Mobile Hotspot configuration web page is
opened, you can change the default settings.
NOTE:
You can also change some settings by touching the screen.

10
Touch Screen Icons and Interfaces

11
1.
External antenna
connector Connect the antenna if necessary.
2.
Power button Press and hold for about 2 seconds to
power on your device.
3.
nano-SIM card
tray Insert your nano-SIM card.
4.
Touch screen
icons Description
Network signal strength
Network type
New SMS
Battery power level
Settings:
Touch to configure the device settings.
Wi-Fi:
Touch to configure the Wi-Fi settings.
Show the number of connected users.
Connected with your computer via a
network cable.
Connected with your computer via a USB
Type-C cable.
5.
LAN port (RJ45) Connect to the computer.

12
6.
Charging/USB
Type-C jack Charge the device or connect to the USB port of a computer.

13
Troubleshooting
Problem Recommended Action
The
connection
between your
device and a
PC through a
USB cable
cannot be
established
automatically.
If the driver of your device is abnormal,
reinstall the software. You need to
uninstall the software first.
The
connection
between your
device and a
client through
Wi-Fi cannot
be
established.
Ensure that the Wi-Fi function is
enabled.
Refresh the network list and select
the correct SSID.
Check the IP address, and ensure
that your client can automatically
obtain an IP address.
Enter the correct network key (Wi-Fi
password) when you connect the
client to your device.

14
Troubleshooting
Problem Recommended Action
The client
connected to
the device
cannot access
the Internet.
Ensure that your nano-SIM card is
available.
Change the location and find a place
with good signal.
Check the settings of the WAN
connection mode.
Contact your service provider and
confirm yourAPN settings.
The 5G Mobile
Hotspot
configuration
page cannot
be visited.
Enter the correct address. Please
view the label on your device to get
the default Device Manager Website
IP address.
Use only one network adapter in your
PC.
Do not use any proxy server.

15
Get More Help
You can get help by:
• Sending an email to [email protected]
• Visiting www.ztedevices.com

16
LEGAL INFORMATION
Copyright © 2020 ZTE CORPORATION.
All rights reserved.
No part of this publication may be quoted, reproduced, translated
or used in any form or by any means, electronic or mechanical,
including photocopying and microfilm, without the prior written
permission of ZTE Corporation.
Notice
ZTE Corporationreservestherightto makemodificationson print
errors or update specifications in this guide without prior notice.
Disclaimer
Images and screenshots used in this guide may differ from the
actual product. Content in this guide may differ from the actual
product or software.
Trademarks
ZTE and the ZTE logos are trademarks of ZTE Corporation.
Other trademarks and trade names are those of their respective
owners.
Version No.: R1.0

17
Label
To check the certification information on you device,from the
home screen, touch About > E-labeling information.
Warning and Notice
To the User
•
If inadequatelyshielded, some electronic devices, for example,
the electronic system of vehicles, may be affected by the
electromagnetic interference caused by the device. Consult
the manufacturers of such devices before using the device if
necessary.
• Operating the device may interfere with medical instruments
such as hearing aids and pacemakers. Always keep the
device more than 20 centimeters away from such medical
instruments when your device is powered on. Power off the
device if necessary. Consult a physician or the manufacturers
of medical instruments before using the device if necessary.
• Be aware of the usage limitation when using the device at
places such as oil warehouses or chemical factories, where
there are explosive gases or explosive products being
processed. Power off the device if necessary.
• Do not use electronic transmission devices in aircraft,at petrol
stations or in hospitals. Observe and obey all warning signs,
and power off the device in these conditions.
• Do not touch the inner antenna area unless necessary.
Otherwise the performance of the device may be affected.
• Do not use the device in an enclosed environment or where
heat dissipation is poor. Prolonged work in such space may

18
cause excessive heat and raise ambient temperature, which
may lead to automatic shutdown of the device for your safety.
In the case of such an event, cool the device in a well-
ventilated place before turning on for normal use.
• Keep the device out of the reach of small children. The device
may cause an injury if used as a toy.
• When the device is operating, do not touch the metallic parts.
Failing to do so may cause burns.
• Use original accessories or accessories that are authorized.
Using any unauthorized accessories may affect the
performance of the device and violate the related national
regulations about telecom terminals.
• Avoid using the device near or inside metallic constructions or
establishments thatcan emit electromagnetic waves, because
signal reception may be affected.
• The device is not waterproof. Keep the device dry and store it
in a shady and cool place.
• Do not use thedevice immediately after a sudden temperature
change, because dew may be generated inside and outside
the device. Do not use it until it becomes dry.
• Handle the device carefully. Do not drop, bend or strike it.
Otherwise the device may be damaged.
• Only qualified personnel can dismantle and repair the device.
• A humidity between 5% and 95% are recommended.
• Do not connect the charger while using the device for a long
period. Failing to do so will trigger the protection mechanism
of the battery, and the battery will not be charged. If you want
to charge the battery, please reconnect the charger.
• Do not connect the charger while using the device for a long
period or use the device and battery in non-operating
temperature. Failing to do so will shorten battery life or cause

19
battery swelling or leakage. If the battery shows signs of
swelling or leakage, please stop use immediately.
Battery Safety
•
Using ZTE-unapproved or incompatible battery, charger or
power adapter may damage your device, shorten its lifespan
or cause a fire, explosion or other hazards.
• Therecommendedoperatingtemperaturesare-10 °Cto 55°C
and the storage temperatures are -20 °C to +60 °C. Extreme
temperatures can damage the device and reduce the charging
capacity and lifespan of your device and battery.
• Do not place the device or the battery in or near heating
equipment, such as microwave ovens, stoves or radiators.
Keepthe deviceandthe battery away fromexcessiveheat and
direct sunlight. If not, the device or the battery may overheat
and cause explosion or fire.
• Please disconnect the charger when the battery is fully
charged. Overcharging may shorten the battery life.
• Do not short-circuit the battery, as this can cause excessive
heat and fire.
• Do not throw the battery into a fire to avoid explosion.
• Do not disassemble, squeeze or puncture the battery, as this
can cause explosion or fire.
• When not using the battery for a long period, please charge
the battery about half then remove the battery from your
device and store it in a cool dry place.
• If the battery damages or shows signs of swelling or leakage,
please stop use immediately and contact ZTE or ZTE
authorized service provider for replacement.
• Return the worn-out battery to the provider or put it in the
designated recycle place. Do not put it in household waste.
• There is a risk of explosion if the wrong battery model is

20
replaced.
WARNING!
If the battery is broken, you should avoid contact with the
contents inside. If they contaminate the skin, immediately rinse
with plenty of water and seek medical help when necessary.
Limited Warranty
This warranty does not apply to defects or errors in the product
caused by:
i. Reasonable abrasion.
ii. End users’ failure to follow ZTE’s installation, operation or
maintenance instructions or procedures.
iii. End users’ mishandling, misuse, negligence, or improper
installation, disassembly, storage, servicing or operation of
the product.
iv. Modifications or repairs not provided by ZTE or a ZTE-
certified individual.
v. Power failures, surges, fire, flood, accidents, and actions of
third parties or other events outside ZTE’s reasonable
control.
vi. Usage of third-party products or usage in conjunction with
third-party products if such defects are due to the combined
usage.
vii. Any other cause beyond the range of normal usage
intended for the product.
End users have no right to reject or return the product, orreceive
a refund for the product from ZTE under the above-mentioned
situations.
This warranty is end users’ sole remedy and ZTE’s sole liability
for defective or nonconforming items, and is in lieu of all other
warranties, expressed, implied or statutory, including but not