ZyXEL Communications ATP Series User manual

1
ATP/USG FLEX/USG20-VPN Series
SOP for firewall
onboarding to Nebula
v1.0 12/04/21
Nebula Together represents Zyxel’s strategy to help customers realize the
power of bringing your whole network together into a single platform.
Powered by Zyxel Nebula

2
Table of Contents
1. Install Hardware
2. Run initial wizard and upgrade firmware
3. Onboard on Nebula Cloud
Nebula Together represents Zyxel’s strategy to help customers realize the power
of bringing your whole network together into a single platform.

3
It is recommended that you configure the security appliance
before using it to protect your network. Use an Ethernet cable to
connect a computer to the LAN port (P4) of the security
appliance.
Use another Ethernet cable(s) to connect a computer to the
WAN port (or P2, if no WAN label) to an Ethernet jack with
Internet access. At the front panel, ensure that the PWR light
turns on. The SYS light blinks during system testing and initialization,
then it should stay on when the system is ready.
Use the included power adaptor or power cord to
connect the power socket (on the rear panel) to a power
outlet.
3
1
Install Hardware
1
1
2

4
We’ll get you quickly up and going with this guide for Zyxel
firewall onboarding to Nebula with DHCP WAN type.
2.1 Login to device GUI with IP: https://192.168.1.1
User name: admin
Password: 1234
Run initial wizard and upgrade firmware
2
2.2 Set up a new
password.
2.3 Use the new
password to login.

5
2.4. Start initial wizard and click Next>
2.5 Connect to Internet(WAN): Select “Ethernet” and choose
“Auto”(DHCP) as WAN type. If you are using PPPoE, please select
PPPoE.

6
2.6 Check the Connection Test showing “OK” then press Next.
2.7 Data and Time Settings- Click Sync. Now then press Next.
2.8 Firmware Upgrade- A new firmware will upgrade automatically.

7
3.2 Create a Zyxel account.
3.1 Go to Nebula Control Center page.
(https://nebula.zyxel.com) and click Get Started .
Create a Zyxel account. If you already have Zyxel account,
please skip to step 3.5.
3.3 Check your email with a
confirmation link and open
the link.
Onboard on Nebula Cloud
3

8
3.4 Set your password and 2FA.
3.5 Click Let’s Start to setup Nebula initial wizard.
3.6 Create your Organization and Site.
If you would not like to enable 2FA, please click Skip.

9
3.8 Click “Skip WiFi Settings”.
3.7 Don’t Skip this step! Add your device’s MAC address and Serial
Number and click Add, then click Next.
3.9 Select DHCP as WAN type and click Next . (If you’re
WAN type is PPPoE, please select PPPoE). The system will
send you an installation email.
+
(MAC address can be found on the sticker. When entering the MAC address,
the colons will automatically be added in.)

10
3.10 Click Go to Nebula dashboard
3.11 Select “Activate one-month trial period“ and click OK.