2gig Technologies Go Control User manual

Arm System –All protected windows and doors must be closed. Ready light should
be green.
Away—From Home Screen- Press SECURITY button, Press ARM button, Press AWAY
Arms all devices including motion detectors.
Stay—From Home Screen- Press SECURITY button, Press ARM button, Press STAY
Arms all devices and automatically bypass all motion detectors.
Instant—From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press STAY
Arms entry doors without delay and bypass all motion detectors.
Maximum: From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press
AWAY
Arms all devices and will arm all entry doors without an entry delay.
Turn System Off: From Security Screen, Press DISARM, Enter Code.
Silence an Alarm: From the Security Screen, Press Disarm, Enter Code.
Reset System/Clear Alarm History: From Home Screen, Press Red Bell Button ,
Check “Clear Alarm History” Button, Press OK
Door Chime On/Off: 2 Different Methods: All Chimes Off: Uncheck CHIME box on 2GIG Main
Menu Screen (From Home Screen Press SECURITY). Individual Chimes Off: Press TOOLBOX
button in Main Menu Screen. Enter Master User Code. From Toolbox menu, press CHIME SETUP.
Select sensor and Chime style/type.
Bypass A Zone: 2 METHODS AVAILABLE: Forced Bypass: From Arming Screen, Press
STAY or AWAY command. Press BYPASS ALL when prompted. Enter User Code.
Manually Bypass: Navigate to TOOLBOX from Main Security Menu Screen. Enter USER code,
Press Bypassed Sensors. Confirm Selections.
Panic Buttons: Press Emergency Button on Front of Alarm Keypad. Select FIRE,
POLICE or EMERGENCY (EMS). Press and HOLD selection for 2 or more seconds.
Change or Add Additional Codes: Navigate to TOOLBOX from Main Security Menu. Press
USER CODE MANAGEMENT. Enter Master Code (#1 User code). Select desired code to change
or next open user code line. Follow prompts to add code. Enable scheduling of code if desired.
Delete A User Code: Navigate to TOOLBOX from Main Security Menu. Press USER CODE
MANAGEMENT. Enter Master Code (#1 User code). Select desired code to erase. Follow prompts
to erase code.
Sending a Test Signal: Navigate to TOOLBOX from Main Security Menu. Press User Code.
Press arrow key to navigate to CELL PHONE TEST or TELEPHONE LINE TEST. Press Code.
Activate test.
856-854-9222 7215 Maple Ave. Pennsauken, NJ 08109 www.iAlarmNJ.com
2GIG Go Control Keypad
2GIG PANEL
KEYPAD QUICKGUIDE
2GIG Home Screen
2GIG Main SECURITY Menu
2GIG Arming Screen