3M PELTOR ComTac VI User manual

3MTM PELTORTM ComTac VI
Quick Guide
3M Personal Safety Division
3M Svenska AB
Dannie Karlsson | Application Engineer
Ingelundsvägen 21
S-33140 Värnamo
Sweden
Email: [email protected]
Telephone: +46 (0) 370 - 65 64 98

Quick guide
2. 4. 5.
Fig 4 Fig 5
Power On/Power Off Surround volume
“Power on/off”
Press and hold the + or – button for two seconds
to power on or off the headset. The voice guide will
conrm with “Power on” or “Power off”.
Press the + or – button to adjust the surround
sound. The lowest and highest sound setting
are conrmed by a “beep” sound.
2s
Replacing the batteries
Fig 1 Fig 2
Fig 3
Insert or replace battery. Make sure the
polarity corresponds to the markings.
Close the lid.
Remove the battery lid..

Fig 6
Menu
Press and hold the + and –
button simultaneously to enter
the menu. The voice guide will
conrm with “Menu”.
Press the – button to navigate
through the different steps,
the voice guide will conrm
each menu step.
Press the + button
to adjust, activate or
deactivate the functions.
“Menu”
Fig 7
Plug mode
2.
“Power on”
Press and hold the + or – button for two seconds to power on
the headset. The voice guide will conrm with “Power on”. Keep
pressing the button until the voice conrm with ”Plug mode”.
7 s
“Plug mode”

2.
“NIB PTT On /
NIB Off /
NIB VOX On.
Fig 8
PTT for face-to-face communication
Double press the PTT button to toggle
between the different modes, NIB PTT On -
NIB Off - NIB Vox On.
Fig 9
2.
Press and hold the PTT button to
transmitt.

Fig 10
Menu Tree