3M HEADSET C1060 Owner's manual

The ESS, Inc.
3M C1060 Wireless Headset Programming Manual
A Step-by-Step Illustrated Guide
© 2007 ESS, Inc.
12113 W Beaver St
Jacksonville, FL 32220
[phone]
www.taylorscommunications.com

Introduction
This document will demonstrate how to Program a 3M C1060 Wireless Headset.
Programming the Headset
The 3M Base Station should be turned On (it probably stays on 24-7 in
your store) and the Programming Station should be connected to the
Base Station (again, it probably already is).
The 3M Programming Station
Swing the microphone to one side until it
reaches the built-in stop.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 2

With the microphone and the buttons fac-
ing Up, insert the bottom end of the head-
set into the Programming Station.
While holding the headset firmly
against the Programming Station,
reach under and turn the headset
On.
Watch the LED next to the T2 but-
ton, it should flash Off and On if it’s
“seeing” the Programming Station.
You should also hear a series of
beeps from the headset’s speaker.
Continue to hold the headset in the
programming station until the
beeps and the flashing LED both
stop. When they both stop, pro-
gramming is complete.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 3

Test the Headset
While standing in front of the Base Station push
the “T1” button on the headset and check to en-
sure that the “Talk” indicator on the Base Station
illuminates in Red.
Repeat for the “Page” button and check to ensure
that the “Page” indicator on the Base Station illumi-
nates in Green.
If both illuminate then the programming was suc-
cessful. Put the headset on and talk to a co-worker
as a final test.
If either “Talk” or “Page” fails go back and program
the headset again, double checking to see either
that the LED flashes Green or that you hear the
programming tones from the headset speaker.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 4

End of Procedure.
Final Notes
Call Us with any questions.
ESS, Inc.
615-340-9033
www.essnashville.com
[email protected]
© 2007 ESS, Inc. All Rights Reserved.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 5
12113 W Beaver St
Jacksonville, FL 32220
[phone]
www.taylorscommunications.com