Aaeon UP Xtreme User manual

Quick Start Guide
Xtreme System
P/N:
User Manuel for UP Xtreme Edge Computing System with Whiskey
Lake CPU
Revision:
01
Update Date:
4 December 2019
Prepared For:
UP Shop User
AAEON
Prepared By:
Wendy Lee
AAEON Europe

Copyright © AAEON
Page 2of 16
Revision History
The following table contains the information regarding the history and
revisions of this living document.
Version
Date
Contributor
Changes Description
01
18 Nov 2019
Eric Duncan
Initial Creation
Document Attributes
The following table contains the list of files that are associated with this
living document.
Filename
Description
N/A

Copyright © AAEON
Page 3of 16

Copyright © AAEON
Page 4of 16
Assembly STEP
1.Take UP Xtreme Chassis and unscrew the top.

Copyright © AAEON
Page 5of 16
2. Take UPX-EDGE_BASE ASY and remove protection film.
UPX-EDGE_BASE ASY
UPX-EDGE_BASE ASYUPX-EDGE_BASE ASYUPX-EDGE_BASE ASY

Copyright © AAEON
Page 6of 16
3.Take the GPIO cable to go through the chassis and
connect the pin head to CN25 (STM32 connector)
1703401600

Copyright © AAEON
Page 7of 16
4.Take the PCB and turn the CPU side downward and put
it in the chassis

Copyright © AAEON
Page 8of 16
5.Take another GPIO cable (1703401301) to go through
the Chassis and connect the pin head to the 40pin HAT
and screw the cable on the chassis.
6.Take the two com ports (#1701100180) and connect the
pin head to COM1 and COM2 and screw the cables on the
chassis.
7.Take debug port cable (1709103100) and connect the
pin head to CN16 and screw the cables with the ring
on the chassis.
1703401600
1701100180
1709103100

Copyright © AAEON
Page 9of 16
8.Screw the support poles*4 on the PCB
Support poles

Copyright © AAEON
Page 10 of 16
9.Screw the panel on the base

Copyright © AAEON
Page 11 of 16
10. Put the top of chassis on and screw it with the e.
M3 Screws *8

Copyright © AAEON
Page 12 of 16
AI Core XM.2 2280 Assembly
1. Screw the plastic screw on the PCB
Put the plastic ring
on the plastic
screws

Copyright © AAEON
Page 13 of 16
2.Put the M.2 2280 on and screw with M3*4

Copyright © AAEON
Page 14 of 16
4. Remove the protection film on the thermal block

Copyright © AAEON
Page 15 of 16
5. Put the top back on. Not that the thermal block
should be the same direction as M.2 2280

Copyright © AAEON
Page 16 of 16
11. Put the top of chassis on and screw it with the e.
M3 Screws *8