ABB FPNO-21 Installation manual

Options for ABB drives, converters and inverters
Quick installation and start-up guide
FPNO-21 PROFINET adapter module
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using
a Torx TX10 screwdriver.
WARNING! Do not use excessive force,
or leave the screw too loose. Over-
tightening can damage the screw or
module. A loose screw decreases the EMC
performance, and can even cause an operation
failure.
13
4
No. Description
1Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1] to Ethernet
4 RJ-45 connector [X2] for chaining another module
5 Diagnostic LEDs
6 MAC ID
5
3
2
4
1
6

Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters.
See the appropriate drive manual.
Basic parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Connectivity configuration
The FPNO-21 adapter module has a web page for connectivity configuration.
To access the web page:
1. Open a web browser and type the IP address of the adapter module in the address field.
The IP address is visible in group 51, parameters 5...8
Example: http://192.168.0.24/
2. Log in with a user name and a password.
The default user name: admin
Password: The last six digits of the MAC address of the adapter module, in upper case letters,
without hyphens. The MAC ID is visible on the front cover of the adapter module.
Example: If the MAC address of the adapter module is 00-1C-01-00-2F-73, the password is 002F73.
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
51.02 Profile The ABB Drives communication profile is the default value.
52.01 FBA A data in1 SW 16bit
52.02 FBA A data in2 Act 16bit
53.01 FBA A data out1 CW 16bit
53.02 FBA A data out2 Ref1 16bit
See the latest version of FPNO-21 PROFINET adapter
module user's manual (3AXD50000158614 [English]) in
ABB library (www.abb.com/drives/documents).
For more information on fieldbus options and protocols
provided by ABB Drives, see the fieldbus
communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
3AXD50000158577 Rev A (EN) 2017-11-23
FPNO-21 manual
Fieldbus communications web page