ABB C13 User manual

1
EN
C13
INSTALLATION MANUAL
Contents
Disclaimer ......................................................................................... 2
Copyright........................................................................................... 2
Trademark......................................................................................... 2
Introduction ....................................................................................... 3
Product Overview.............................................................................. 3
Installation ......................................................................................... 6
Installation Requirements.................................................................. 7
Troubleshooting ................................................................................ 7
Service and Maintenance.................................................................. 8
C13_install.book Page 1 Thursday, May 30, 2013 4:36 PM

2
Disclaimer
The information in this document is subject to change without notice
and should not be construed as a commitment by ABB AB. ABB AB as-
sumes no responsibility for any errors that may appear in this docu-
ment.
In no event shall ABB AB be liable for direct, indirect, special, incidental
or consequential damages of any nature or kind arising from the use of
this document, nor shall ABB AB be liable for incidental or consequen-
tial damages arising from use of any software or hardware described in
this document.
Copyright
This document and parts thereof must not be reproduced or copied
without written permission from ABB AB, and the contents thereof must
not be imparted to a third party nor used for any unauthorized purpose.
The software or hardware described in this document is furnished un-
der a license and may be used, copied, or disclosed only in accordance
with the terms of such license.
© Copyright 2013 ABB AB. All rights reserved.
Trademark
ABB AB is a registered trademark of the ABB Group. All other brand or
product names mentioned in this document may be trademarks or reg-
istered trademarks of their respective holders.
C13_install.book Page 2 Thursday, May 30, 2013 4:36 PM

3
EN EN
Introduction
The C13 meter is a direct connected electricity meter for DIN-rail
mounting in distribution boards or small enclosures.
Read the information in this manual carefully before you install the
equipment.
Product Overview
Part Description
1 Terminal for output connections
1
11
2
2
6
5
4
8
3
7
8
C13_install.book Page 3 Thursday, May 30, 2013 4:36 PM

4
2 Sealing points
3 Push button for programing and reading the meter. For
detailed information, refer to the C11 User Manual.
4 LED, flashes in proportion to the energy measured
5 Display
6 Sealing label
7 Sealable terminal cover
8 Terminal block
Technical Data
Voltage
Voltage range 3 x 220-240/380-415 V (-20% to +15%)
Terminal wire area
Tightening torque
0.5 - 10 mm²
0.8 Nm
Current
- base Ib
- reference Iref
- maximum Imax
- minimum Imin
5 A
5 A
40 A
0.25 A
Part Description
C13_install.book Page 4 Thursday, May 30, 2013 4:36 PM

5
EN EN
Frequency 50 or 60 Hz ± 5%
Accuracy 1% (Cl.1, Cl. B)
Material Polycarbonate in transparent front glass.
Glass reinforced polycarbonate in bottom
case and upper case. Polycarbonate in ter-
minal cover.
Operating temp. -25 °C to +70 °C
Storage temp. -25 °C to +85 °C
Humidity 75% yearly average, 95% on 30 days/year
Resistance to heat Terminal 960°C, cover 650°C (IEC 60695-
2-1)
Outputs
Current 2 - 100 mA
Voltage 5 - 40 VDC
Pulse frequency 100 imp/kWh
Pulse length 200 ms
Terminal wire area 0.5-6 mm²
Tightening torque 0.8 Nm
Pulse indicator(LED)
Technical Data
C13_install.book Page 5 Thursday, May 30, 2013 4:36 PM

6
Installation
For information about how to mount and install the equipment, follow
the instructions in the Installation Guide at the end of this manual.
E Warning – Working with high voltage is potentially lethal. Per-
sons subjected to high voltage may suffer cardiac arrest, burn
Pulse frequency 1000 imp/kWh
Pulse length 40 ms
EMC compatibility
Impulse voltage test 6 kV 1.2/50μs (IEC 60060-1)
Surge voltage test 4 kV 1.2/50μs (IEC 61000-4-5)
Fast trans. burst test 4 kV ( IEC 61000-4-4 )
Immunity HF-fields 80 MHz - 2 GHz at 10 V/m (IEC61000-4-3)
Immunity conducted 150kHz – 80MHz ( IEC 61000-4-6 )
RF Emission EN 55022, class B (CISPR22)
ESD 15 kV ( IEC 61000-4-2 )
Standards IEC 62052-11, IEC 62053-21 class 1, GB/T
17215.211-2006, GB/T 17215.321-2008
class 1 & 2, GB 4208-2008, EN 50470-1,
EN 50470-3 category B
Technical Data
C13_install.book Page 6 Thursday, May 30, 2013 4:36 PM

7
EN EN
injuries, or other severe injuries. To avoid such injuries, make
sure to disconnect the power supply before you start the instal-
lation.
Electrical equipment should only be installed, accessed, ser-
viced and maintained by qualified electrical personnel.
E Warning – For safety reasons it is recommended that the
equipment is installed in a way that makes it impossible to
reach or touch the terminal blocks by accident.
The best way to make a safe installation is to install the unit in
an enclosure. Further, access to the equipment should be lim-
ited through use of lock and key, controlled by qualified electri-
cal personnel.
W Warning – The meters must always be protected by fuses on
the incoming side.
Do not operate the equipment outside the specified technical
data.
Installation Requirements
To comply with the protection requirements the meter must be
mounted in protection class IP 51 enclosures, or better, according to
IEC 60259.
Meters with wireless communication should not be installed closer
than 20 cm from people.
Troubleshooting
If the Wicon appear in the display after the installation has been com-
pleted and power has been connected to the meter, refer to the C13
User Manual for detailed information.
C13_install.book Page 7 Thursday, May 30, 2013 4:36 PM

8
Service and Maintenance
The meter contains no parts that can be repaired or exchanged. A bro-
ken meter must be replaced.
If the meter needs to be cleaned, use a lightly moistened cloth and a
mild detergent to wipe it.
C Caution – Be careful that no liquid gets into the meter since it
may damage the equipment.
C13_install.book Page 8 Thursday, May 30, 2013 4:36 PM

1
SV
C13
INSTALLATIONSMANUAL
Contents
Friskrivning........................................................................................ 2
Copyright........................................................................................... 2
Varumärke......................................................................................... 2
Introduktion ....................................................................................... 3
Produktöversikt ................................................................................. 3
Installation ......................................................................................... 7
Installationskrav ................................................................................ 7
Felsökning......................................................................................... 8
Service och underhåll........................................................................ 8
C13_install.book Page 1 Thursday, May 30, 2013 4:36 PM

2
Friskrivning
Informationen i detta dokument är föremål för ändringar utan föregå-
ende meddelande och ska inte betraktas som ett åtagande från ABB
AB. ABB AB tar inte något ansvar för fel som kan uppträda i detta doku-
ment.
I inget fall ska ABB AB vara ansvarig för direkta, indirekta, speciella,
oförutsedda eller följdskador av något slag eller typ som uppkommer
vid användning av detta dokument, ej heller ska ABB AB vara ansvarig
för oförutsedda eller följdskador som uppkommer vid användning av
mjukvara eller hårdvara som beskrivs i detta dokument.
Copyright
Detta dokument och delar därav får inte reproduceras eller kopieras
utan skriftligt tillstånd från ABB AB, och innehållet däri får inte vidare-
befordras till tredje part eller användas för något icke godkänt syfte.
Den mjukvara eller hårdvara som beskrivs i detta dokument tillhanda-
hålls under licens och får endast användas, kopieras eller röjas i enlig-
het med villkoren i licensen.
© Copyright 2013 ABB AB. Alla rättigheter förbehållna.
Varumärke
ABB AB är ett registrerat varumärke tillhörande ABB-koncernen. Alla
övriga märkes- eller produktnamn som nämns i detta dokument kan
vara varumärken eller registrerade varumärken som tillhör respektive
innehavare.
C13_install.book Page 2 Thursday, May 30, 2013 4:36 PM