abi 14404 User manual

Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right to
vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI and
the manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2022.
Note: Dimensions are nominal measurements only
SPECIFICATIONS
RECOMMENDED USE
MATERIAL
TEMPERATURE RATINGS
PRESSURE RATINGS
SUITABLE FOR HOT WATER UNITS
COMMERCIAL PULL OUT SPRAY ATTACHMENT
Domestic
304 Stainless Steel
Maximum continuous working temperature 75oC
If the water exceeds 75oC, an approved temper-
ing valve must be fitted
Recommended minimum working pressure 0.2 Bar
Recommended maximum working pressure 5 Bar
Hot and cold water inlet pressure should be equal
Storage tank: Yes
Continuous flow: Yes
Gravity fed system: Not Suitable
n
n
n
n
AS/NZS 3718:2005
WM-022852

INSTALLATION GUIDE
This product must be installed by a licensed plumber. This is a general installation guide - there are many
factors involved that can alter the installation method.
AU/NZ: For installations within Australia and New Zealand, this product must be installed in compliance
with AS/NZS 3500.
UK: For installations in the United Kingdom this product must be installed in compliance with the Water
Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws.
Other: For installations outside these countries, this product must be installed in compliance with the
standards in your respective country.
DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material.
1Pull nozzle out from mixer. Secure hose and unscrew pull-out nozzle
to remove. Obtain the O-ring from between
the hose and nozzle.
1. Insert O-ring into hose.
2. Replace pull out nozzle with
spray attachment.
Tighten spray attachment onto pull-out
hose. O-ring should be in between nozzle
and hose.
1x Spray Attachment
2
34
IN THE BOX

INSTALLATION GUIDE
This product must be installed by a licensed plumber. This is a general installation guide - there are many
factors involved that can alter the installation method.
AU/NZ: For installations within Australia and New Zealand, this product must be installed in compliance
with AS/NZS 3500.
UK: For installations in the United Kingdom this product must be installed in compliance with the Water
Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws.
Other: For installations outside these countries, this product must be installed in compliance with the
standards in your respective country.
DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material.
USER GUIDE
Down PositionNeutral Position
* During low pressure use, the switch will automatically shift to neutral position