abi ATLEY 12996 User manual

ATLE Y F LUS H P ULL RO UND
Disclaimer: P ro d u c ts in th is ma n u a l mu s t b y la w b e in s ta lled b y licen s ed a n d reg is tered tra des peo ple in a cc o rd a n ce w ith th e relev a n t s ta n d a rd s . A B I a n d th e ma n u fa c tu rer/dis trib u to r
res erve th e rig h t to v a ry s p ec if ica tio n s o r d elet e mo d els fro m th eir ra n g e w ith o u t p rio r n o tifica tio n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in fo rma t io n lis ted is co rrect a t th e time
o f p u b lica tio n , h o w ever A B I a n d t h e ma n u fa c t u rer/dis trib u to r ta k es n o res po n s ibility f o r p rin tin g erro rs . C o py rig h t © A B I I n terio rs 2 02 2 P ty Ltd
SPECIFICATIONS
MATERIAL 304 Stainless Steel
FUNCTION Pull or Slide

DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material.
INSTALLATION GUIDE
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with the standards in your
respective country and must be adhered to by your licensed tradesperson.
Note: This product must be installed by a licensed trade
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INSTALLATION GUIDE
Measure the desired height that you wish
for the flush pull to sit at and mark a fixed point.
Mark the required circumference of the flush
pull from its rear box (this is the back section of
the flush pull).
Apply the necessary amount of adhesive as
required to the cut surface.
Use a multi tool or preferred method to
evenly remove material to the correct depth.
Press the flush pull into the cavity. Use fixings provided to secure flush pull
into position
1 2
34