Acer PD116P User manual

PD116P
Service Guide
PRINTED IN TAIWAN
Service guide files and updates are available
on the AIPG/CSD web; for more information,
please refer to http://csd.acer.com.tw

II
Revision History
Please refer to the table below for the updates made on PD116P service guide.
Date Chapter Updates

III
Copyright
Copyright ©2005byAcer Incorporated. All rightsreserved. No part of thispublication may bereproduced,
transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in
any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without
the prior written permission of Acer Incorporated.
Disclaimer
The information in this guide is subject to change without notice.
Acer Incorporated makes no representations or warranties, either expressed or implied, with respect to the
contents hereof and specifically disclaims any warranties of merchantability or fitness for any particular
purpose. Any Acer Incorporated software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not Acer Incorporated, its distributor, or its
dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential
damages resulting from any defect in the software.
Acer is a registered trademark of Acer Corporation.
Intel is a registered trademark of Intel Corporation.
Pentium 4 and Celeron are trademarks of Intel Corporation.
Other brand and product names are trademarks and/or registered trademarks of their respective holders.

IV
Conventions
The following conventions are used in this manual:
Screen messages Denotes actual messages that appear
on screen.
NOTE Gives bits and pieces of additional
information related to the current
topic.
WARNING Alerts you to any damage that might
result from doing or not doing specific
actions.
CAUTION Gives precautionary measures to
avoid possible hardware or software
problems.
IMPORTANT Reminds you to do specific actions
relevant to the accomplishment of
procedures.

V
Preface
Before using this information and the product it supports, please read the following general information.
1. This Service Guide provides you with all technical information relating to the BASIC CONFIGURATION
decided for Acer's "global" product offering. To better fit local market requirements and enhance product
competitiveness, your regional office MAY have decided to extend the functionality of a machine (e.g.
add-on card, modem, or extra memory capability). These LOCALIZED FEATURES will NOT be covered
in this generic service guide. In such cases, please contact your regional offices or the responsible
personnel/channel to provide you with further technical details.
2. Please note WHEN ORDERING FRU PARTS, that you should check the most up-to-date information
available on your regional web or channel. If, for whatever reason, a part number change is made, it will
not be noted in the printed Service Guide. For ACER-AUTHORIZED SERVICE PROVIDERS, your Acer
office may have a DIFFERENT part number code to those given in the FRU list of this printed Service
Guide. You MUST use the list provided by your regional Acer office to order FRU parts for repair and
service of customer machines.

VI

1Chapter 1
System Introduction
+D=FJAH
Technical Specification
metI noitpircseD
)DxHxW(snoisnemiDmm8.632x1.701x772
thgieW)gK94.2(sl5.5.xorppA
elgnAtliTmsinahcemrotavelehtiweerged7
noitcerrocenotsyeK)eerged23(eerged61-/+
noitcejorProoDpmaL neporoodnehwyllacitamotuaffotuhsylppusrewoppmaL
ylppuSrewoP
tupniCFPhtiwzH06-05~V042-001CAlasrevinU
noitarepolamron@pmaLOIHSUrofW002
erutarepmetnosdnepeD(lortnocdeepsNAFecnairaV
)tnairav
sneLnoitcejorP x2.1,m4.2@18.2~6.2/F,m4.2@mm8.62~mm43.22=f
sneLmooZlaunaM
ecnatsiDworhTm01~m5.1
ssenthgirB
)edomrewoplluF;lacipyT(snemuLISNA0071
)edomocE;lacipyT(snemuLISNA5721
rewoplluF;muminiMgnireenignE(snemuLISNA0631
)edom
tsartnoC )edomrewoplluF;muminiM(kcalBdnaetihWlluF1:0001
)edomrewoplluF;lacipyT(kcalBdnaetihWlluF1:0051
ytimrofinU )edomrewoplluF;muminiM(dradnatsnapaJ%06
)edomrewoplluF;lacipyT(dradnatsnapaJ%57
erutarepmeT 53~5:gnitaretpO
o
C
06~02-:egarotS
o
C
ytidimuHmumixaM 53~5-:gnitarepO
o
gnisnednoc-non,).xaM(HR%08,C
06~02-:egarotS
o
gnisnednoc-non,).xaM(HR%08,C
levelesioncitsuocA 2-/+32rednU,lacipyT,)A(Bd63
o
edomrewoplluF;C
2-/+32rednU,lacipyT,)A(Bd33
o
edomocE;C
efiLpmaL )edomrewoplluF(etarlavivrus%05,nimsruoh0002
)edomocE(etarlavivrus%05,nimsruoh0052
edutitlA
5roftf005,2~0:gnitarepO
o
53~C
o
C
5roftf000,5~005,2
o
03~C
o
C
5roftf000,01~000,5
o
52~C
o
C
).xaM(tf000,04:egarotS
FBTM )leveLecnedifnoC%09(sruoh000,21nahteromgnitarepO

Chapter 1 2
Product Overview
Main Unit
metI noitpircseD
1gniRsucoF
2gniRmooZ
3sneLmooZ
4nottuBrotavelE
5tooFrotavelE
6revieceRlortnoCetomeR
7stroPnoitcennoC
8tekcoSrewoP
9lenaPlortnoC
4
6
5
3
1
2
8
7
9
6

3Chapter 1
Panel Control
metI noitpircseD
1DELrotacidnIpmaL
2DELrotacidnIpmeT
3)DELrewoP(DELrotacidnIdnaydnatS/rewoP
4ecruoS
5cnyS-eR
6syeKtceleSlanoitceriDruoF
7retnE/uneM

Chapter 1 4
Connection Ports
metI noitpircseD
1tupnIoediVtnenopmoC/VTDH/langiSgolanACP
rotcennoC
2rotcennoCtuptuOhguorht-pooLrotinoM
3rotcennoCBSU
4rotcennoC232SR
5rotcennoCtupnIoediV-S
6rotcennoCtupnIoediVetisopmoC
7rotcennoCtupnIoiduA
8revieceRlortnoCetomeR
9notgnisneK
MT
troPkcoL
43 2 1
98 7 6 5

5Chapter 1
Connecting the Projector
metI noitpircseD
1droCrewoP
2elaCAGV
3elaCoediVetisopmoC
4elaCBSU
5retpadAVTDH/tnenopmoCotAGV
6elaCoediV-S
7)yrosseccAlanoitpO(ACR/kcaJelaCoiduA
8)yrosseccAlanoitpO(elaC232SR
8
Audio

Chapter 1 6
System Block Diagram
AD9883

7Chapter 2
Firmware Upgrade
+D=FJAH
This chapter provides the equipment needed, setup and upgrading procedure for Firmware
upgrade.
Equipment Needed
metI noitpircseD
erawtfoS resopmoCPLD
erawmriFP611DP
erawdraH
droCrewoP
)100.60068.24:/P(elbaCBSU
potpaLroCP
rotcejorPP611DP
Setup Procedure
1. Connect USB of C and USB port of D116 projector.
USB Cable
USB ort

Chapter 2 8

Installation Procedure
A. DLP Composer Installation Procedure
1. Execute the DL Composer Lite V3.x Setup program.
2. Click Next icon.

9Chapter 2
3. Select I accept and agree to be bound by all the terms and conditions of this
License Agreement, then Click Next icon.
4. Select All and then click Next icon.
1
2
1
2

Chapter 2 10
5. Click Finish to complete the installation.
6. Click Yes to restart the computer.

11 Chapter 2
Installation Procedure
B. USB Driver Upgrade Procedure
1. After linking the C and D116 projector with a USB cable, press and hold
the menu button, then push the power button to turn on the projector.
Note : The Temp LED and Lamp LED should be full on.
2. Execute the C:\ rogram files\DL Composer\usbupdata.cmd.
Note : The DLP Composer program must be closed first.
1
2
3. Type any key to continue. Then wait about a minute.

Chapter 2 12
4. Click OK. The USB driver updated successfully.
5. Right click My Computer on the desktop. Select  roperties on the popup
menu to launch the System roperties window. Choose Hardware and then
click Device Manager.
My Computer Hardware Device Manager
System roperties

13 Chapter 2
6. Click Jungo to assure DD 2000 and WinDriver are properly installed. If
not, repeat Step 1 ~ 6.
Device Manager

Chapter 2 14
Firmware Upgrade Procedure
1. Execute the DL ComposerTM file.
1
2
2. Click Edit and  references.