Addonics Technologies Jasper II 3M User manual

CONTACT US
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Jasper II 3M – 1:3 M2/mSATA/2.5” HDD/SSD
High Speed duplicator
Model: JD2-3M
Default settings on the duplicator:
Copy – set to copy system and file. This is for drives that have the following
file system: NTFS, FAT/16/32, eXFAT, HFS, EXT3/4 or XFS. For other file
systems and boot drives, you may need to change the setting to WHOLE
MEDIA
Performance – set to SPEED for best performance. May encountered
compatibility issue with certain SSD. Should that occur, try to change the
setting to BALANCE or COMPATIBILITY.
HPA – set to SKIP.
Please review the Jasper II Duplicator user guide for all the detail settings.
Making duplicates
Power up the unit by pressing on the ON/OFF button at the front lower right
hand corner. Once the unit is ready, the LCD should display
HDD Duplicator
1. Copy
The unit is now ready. Simply load a source drive to the source slot (the first
bay on the top) and up to three target drives to the target slots (the three lower
bays). After a few seconds, the LCD should display the number of target drives
detected. Press the OK button on the LCM control panel to start the copying.
Note: some drives may not be detected correctly. In that case, please leave the
drive inside the unit and re-starting the duplicator.

www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email. www. Addonics.com/support/query/
Overview Rear view
M2 SSD installation mSATA SSD installation
WARNING
Be sure to set the 110/240V
switch to the correct setting
to your local outlet before
powering on the unit. Wrong
setting may cause damage
to the power supply
Package content:
•Jasper II 1:3 duplicator main unit
•Four (4) units of 2.5” M2/mSATA flash drive adapter (model: AD25M2MSA)
•One power cord
•One 12” eSATA cable (use for daisy chaining to another Jasper II duplicator)
•This quick start user guide for Jasper II 3M
•Jasper II duplicator user guide