ADJ SPL-FSRG-017N-B6 User manual








SPL‐FSRG‐017N‐B6

User Instructions

1A
CONTENTS

1.SafetyInstructions............................................................................................................................2
2.TechnicalSpecifications....................................................................................................................3
3.ControlPanel....................................................................................................................................4
4.IRController.....................................................................................................................................5
5.Troubleshooting...............................................................................................................................6
6.FixtureCleaning...............................................................................................................................6



2A
1.SafetyInstructions

WARNING
PLEASEkeepthisUserManualforfutureconsultation.Ifyousellthefixturetoanotheruser,
makesurethattheyalsoreceivethisinstructionbooklet.
PLEASEunpackandcheckcarefullythereisnotransportationdamagebeforeusingthefixture.
It’simportanttogroundtheyellow/greenconductortoearthinordertoavoidelectricshock.
PLEASEdisconnectmainpowerbeforeservicingandmaintenance.
Intheeventofseriousoperatingproblem,stopusingthefixtureimmediately.Nevertryto
repairthefixturebyyourself.Repairscarriedoutbyunskilledpeoplecanleadtodamageor
malfunction.Pleasecontactthenearestauthorizedtechnicalassistancecenter.Alwaysusethe
sametypespareparts.
DONOTconnectthedevicetoanydimmerpack.
DONOTtouchanywireduringoperationandtheremightbeahazardofelectricshock.
Thehousingmustbereplacediftheyarevisiblydamaged.
Topreventorreducetheriskofelectricalshockorfire,donotexposetheunittorainor
moisture.
DONOTopentheunitwithinfiveminutesafterswitchingoff.
Thehousing,thelenses,ortheultravioletfiltermustbereplacediftheyarevisiblydamaged.
Caution:
Therearenouserserviceablepartsinsidetheunit.DONOTopenthehousingorattemptany
repairsyourself.Intheunlikelyeventyourunitmayrequireservice,pleasecontactyournearest
dealer.

Pleasereadtheinstructionscarefullywhichincludesimportant
informationabouttheinstallation,operationandmaintenance.
CAUTION!
Possibly hazardous optical radiation emitted from this product.

3A
2.TechnicalSpecifications
Themust‐seehybridlightingeffect.
80mW650nmredlaser,30mW532nmgreenlaser.
Adjustablemicrophonesensitivity.
IRControl,Soundactive&auto‐play.

PowerVoltage:DC12V
Consumption:10W
Lasers:80mW650nmRedx1,30mW532nmGreenx1
Weight:0.49kg
Dimension:134X198X55mm


4A
3.ControlPanel
AmericanVersion:

EuropeanVersion:

1.ModePressthisbuttontoselectSoundmode,AutoFastModeorAutoslowMode;
2.MIC:Toreceivemusicforsoundactive;
3.LED1) Turngreenwhenpoweron;
2) Turnoffwhenpoweroff;
3) GreenLEDindicatorflickwiththefrequencyofstrobe.
4.IRreceiverToreceivetheIRsignal;
5.VOL:ToadjustsoundsensitivitywheninAutoFastmodeorAutoSlowmode;
6.ON/OFF:Rotatetoturnonthefixtureandadjustthespeedofshow;
6.DC12V:DCpowersocket,workvoltageDC12V;
7.KeyforLaser:Toturnon/offthelaserLed.(OnlyforEUversion)

5A
4.IRController
YoucansettheunitviaIRcontroller(Soldseparately).
Standby
Pattern‐ PatternPattern+
Speed‐ SpeedSpeed+
RGB
R+GG+BB+R
R+G+BRandomStrobe
SoundAutoFastAutoSlow
Thekeyvalueswillbesavedwhenpoweroff.
Standby:Pressthebuttontoblackouttheunit,pressagaintoexitthestatus.
Pattern:Pressthebuttontorandomshow.
Pattern+/Pattern‐:Pressthebuttontocounterclockwiseorclockwiserotation.
Speed:Pressthebuttontoselectshowspeed
Speed+/Speed‐:Pressthebuttontospeeduporspeedcuttheshow.
R:PressthebuttontoselectRedlaser.
G:PressthebuttontoselectGreenlaser.
B:NoFunction.
R+G:PressthebuttontoselectRedlaserandGreenlaser.
G+B:NoFunction.
B+R:NoFunction.
R+G+B:NoFunction.
Random:Pressthebuttontoselectrandomcolor.
Strobe:Pressthebuttontostrobe,pressagaintobacktothepreviousshow.
Sound:Pressthebuttontoturnonthesoundcontrol.
AutoFast:Pressthebuttontorunfastautomaticallywithoutsoundcontrol.
AutoSlow:Pressthebuttontorunslowlyautomaticallywithoutsoundcontrol.


6A
5.Troubleshooting
Followingareafewcommonproblemsthatmayoccurduringoperation.Herearesome
suggestionsforeasytroubleshooting:
A. Thefixturedoesnotwork,nolight
1. Checktheconnectionofpowerandmainfuse.
2. Measurethemainsvoltageonthemainconnector.

6.FixtureCleaning
Thecleaningmustbecarriedoutperiodicallytooptimizelightoutput.Cleaningfrequency
dependsontheenvironmentinwhichthefixtureoperates:moist,smokyorparticularlydirty
surroundingcancausegreateraccumulationofdirtonthefixture.
Cleanwithsoftclothusingnormalglasscleaningfluid.
Alwaysdrythepartscarefully.
Cleantheexternalopticsatleastevery30days.