Advance acoustic SC900 Instruction Manual

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
2. Inspect the pads or brushes for wear
and install them on the machine. Lift
the lugs into the slots and rotate the
brushes to lock them into place.
1. Turn the machine on and check the
status of the batteries. If two bars
or less are showing, charge the
machine for 2 to 8 hours.
3. Check the squeegee blades for wear
and flip or replace if worn, nicked
or torn. Install squeegee and hand
tighten thumb nuts.
4. Inspect and clean the solution filter
as required.
Filter – pn 56104351
18. Charge the machine for 8 hours.
16. Rinse the recovery tank and leave
the lid open to dry. Inspect the
float ball cage.
17. Empty the clean water
solution tank.
13. Inspect and clean the debris catch
cage. Refill the clean water tank
as required.
12. When the vacuum motor changes
pitch the recovery tank is full and
needs to be emptied. Refill the
clean water tank as required.
10. Select the desired solution flow rate
based on the soil conditions.
11. Propel the machine forward using
the yellow palm switches.
14. When finished using the machine,
remove the pads or brushes.
Inspect and clean or replace them
as required.
15. Clean and inspect the squeegee
blades. Flip the blade or replace it
if required. Hang the squeegee on
the machine as shown.
Tan Gum Rubber Blades – pn 56115334
Red Linatex Blades – pn 56115333
7. Press the yellow palm switch on the
back of the handle to go in reverse.
5. Fill the tank with the appropriate
cleaning solution.
Yellow Cap – pn 56115395
6. Press the yellow palm switches on
the front of the handle to transport
the machine to an area for cleaning.
8. Lower the scrub deck to the floor
using the foot pedal. Select low,
medium or high scrub pressure.
9. Lower the squeegee to the floor
and the vacuum motor will start.
If the machine has been used until the low battery level indicator is on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this procedure may cause damage
to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE.
OPERATING GUIDELINES
SC900™

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
Why isn’t there
enough water
being dispensed?
Why is water
being left on the
floor?
Daily
Maintenance
Weekly
Maintenance
TROUBLESHOOTING & MAINTENANCE
SC900™
1. Check the water level of the tank. 2. Check the solution shut off valve. 3. Check the solution filter.
1. Check the squeegee for wear and
even fold over.
1. Inspect the squeegee for wear and
replace as required.
3. Inspect the recovery tank gasket
and hoses.
2. Check the squeegee hose
connection and suction.
2. Inspect the pads/brushes for wear
and replace as required.
14 in Pad Driver – pn 56505800
3. Charge the machine for at least
8 hours.
2. Inspect and clean the solution filter.
3. Inspect the recovery lid gasket.
Gasket – pn 56104164
1. Check the level of the batteries and
add distilled water as required.
4. Make sure to avoid tight turns.