Advantech PCM-9342 Installation and operation manual

PCM-9342 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
1 PCM-9342 SBC
1 Startup Manual
1 Utility CD
1 Mini jumper pack p/n: 9689000002
1 SATA cable p/n: 1700008894
1 Keyboard/Mouse cable p/n: 1700060202
2 COM3/COM4 cable p/n: 1700100250
1 Parallel port cable p/n: 1700260250
1 COM2 cable p/n : 1701140201
1 USB 2 port cable p/n: 1703100121
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note 1: For detailed contents of the PCM-9342, please
refer to information on the enclosed CD-ROM (in
PDF format).
Note 2: Acrobat Reader is required to view any PDF
file.Acrobat Reader can be downloaded at:
www.adobe.com/Products/acrobat/readstep2.
html (Acrobat is a trademark of Adobe®)
•
•
•
•
•
•
•
•
•
•
PCM-9342 EVA-X4150 3.5” SBC with PC/104, VGA/
TTL/LVDS Ethernet/USB 2.0 and SSD
Startup Manual
General
CPU: Advantech EVA-X4150 SoC
System Chipset: Advantech EVA-X4150 SoC
System Memory: 64 MB onboard SDRAM
BIOS: Award 4-Mbit Flash BIOS
Watchdog Timer: 255 level timer interval
Expansion Interface: PC/104
Battery: Lithium 3 V/210 mAH
SATA interface: Two SATA ports (100 MB/s transfer from
IDE)
Parallel port: One parallel port, supports SPP/EPP/ECP-
mode, shared with FDD
Keyboard/mouse connector: Supports one standard
PC/AT keyboard and a PS/2 mouse
USB: Two USB 2.0 compliant universal serial bus ports
GPIO: 8-bit general purpose Input/Output
Solid State Disk
Supports one 50-pin socket for CFC type I/II
VGA/LVDS Interface
Chipset: SMI SM712 2D Graphic Chip
Memory Size: built-in 4 MB display memory on SM712
Resolution:
- CRT display mode: pixel resolution up to 1024 x 768
@85 Hz
- LVDS display mode: 1024 x 768 at 65 MHz
TTL LCD: supports 24-bit TTL LCD
LVDS LCD: supports 18-bit LVDS LCD
Dual Simultaneous Display:
- CRT + LVDS
- CRT + TTL
Ethernet Interface
Chipset supports: 10/100 Mbps - Realtek RTL8100CL
(With Wake on LAN)
Ethernet interface: IEEE 802.3u (100 BASE-T) protocol
compatible
Built-in boot ROM
RJ45 connector equipped
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Specications
Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://www.advantech.com/support/
This manual is for the PCM-9342 series Rev. A1
Part No. 2006934200
Printed in China
1st Edition,
Nov. 2008

2 PCM-9342 Startup Manual
Specications
Mechanical and Enviromental
Dimensions: 145 x 102 mm (5.9” x 4.2”)
Mechanical drawing is available.
Power Supply Type: AT
Power Requirement: +5 V ± 5%, +12 V ±5% (Optional)
or supports single +5 V only
Power Consumption: DOS Mode: +5 V @1.18 A (5.9 W)
Operating Temperature: 0 ~ 60° C (32 ~ 140° F)
Weight: 0.85 kg (reference weight of total package)
Jumpers and Connectors
The board has a number of jumpers that allow you to
configure your system to suit your application.
The table below lists the function of each of the jumpers and
connectors.
Jumpers
Label Function
J1
LCD Power
J2 COM2 Setting
J3 HDD & PWR LED Setting
J4 CPU CLK Setting
J5
CPU CLK Setting
J6
CPU CLK Setting
•
•
•
•
•
•
Connectors
Label Function
CN5
VGA
CN6 SATA
CN7 SATA
CN9 Internal USB
CN11 COM2
CN12 LPT
CN14 COM3
CN15 COM4
CN16 24-bit TTL Panel
CN17
Inverter Power Output
CN18 18-bit LVDS Panel
CN19 LAN
CN20 ISA -5V & -12V Input
CN21 PC104
CN25 AT Power Input
CN32 GPIO
CN33 Battery
CN34 PS2
CN35 CF
CN36 COM1
Jumpers and Connectors

PCM-9342 Startup Manual 3
J4-J6
CPU CLK Setting
Description
PIN HEADER 3*1P 180D(M) 2.0 mm
DIP SQUARE W/O Pb
Setting
Function
(2-3)(2-3)(2-3) 66 MHz CPU/SDRAM Frequency
(2-3)(2-3)(1-2) 100 MHz
(2-3)(1-2)(2-3)* 133 MHz
(2-3)(1-2)(1-2) 150 MHz w 37.5MHz PCI
(1-2)(2-3)(2-3) 150 MHz w 30 MHz PCI
(1-2)(2-3)(1-2) 166 MHz
*: Default
Jumper Setting
J1 LCD Power
Description
PIN HEADER 3*1P 180D(M) 2.0 mm
DIP SQUARE W/O Pb
Setting Function
(1-2)
+5 V
(2-3)* +3.3 V
*: Default
J2
COM2 Setting
Description
PIN HEADER 3*2P 180D(M) 2.0 mm
SMD SOUARE PIN
Setting
Function
(1-2)* RS-232
(3-4) RS-485
(5-6) RS-422
*: Default
J3 HDD & PWR LED Setting
Description
PIN HEADER 2*2P 180D SMD MALE
SQUARE 2.00 mm
Setting
Function
(1-2) (3-4)* IDE (Yellow) Power (Green)
(1-3) (2-4) IDE (Green) Power (Yellow)
*: Default
Jumpers and Connectors Jumpers and Connectors

4 PCM-9342 Startup Manual
Jumpers and Connectors (Top)
Jumpers and Connectors (Bottom)
Board Layout
J6
J5 CN7 CN6
CN17 CN16 CN18 J1
CN25
CN12
CN14
CN15
J3
CN32
Power &
HDD LED
ResetCN5
CN34
CN19
LAN
LED
CN11
CN36
CN9
J2
CN33
CN21
J4
CN20
CN35

PCM-9342 Startup Manual 5
Board Dimension (Top)
Board Dimension (Bottom)
Board Dimension

6 PCM-9342 Startup Manual
Board Dimension
Board Dimension (Side)