Warning: This is a Class A product. In domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.
1. Read these safety instructionscarefully.
2. Keep this user manual for later reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socke must
be located near the equip-ment and must be easily
accessible.
5. Keep this equipment away fromhumidity.
6. Put this equipment on a reliable surface during
installation. Dropping it or letting it fall may cause
damage.
7. The openings on the enclosure are fo air convection.
Protect the equipment from overheating. DO NOT
COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
9. Position the power cord so that people cannot step
on it. Do not place anything over the powercord.
10. All cautions and warning on the equipment should
be noted.
11. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
over voltage.
12. Never pour any liquid into an opening. This may cause
fire or electricalshock.
13. Never open the equipment. For safety reasons, the
equipment should be opened only by qualified
service personnel.
1. Position one bracket to align with the holes on one
side of the switch and secure it with the bracket
screws. Then attach the remaining bracket to the
other side of the Switch.
2. After attaching the mounting brackets, position the
EKI-2428G-4FA Ummanaged Switch in the rack by
lining up the holes in the brackets with the appropriate
holes on the rack. Secure the Switch to the rack by a
screw driver with the rack-mounting screws.
14. If one of the following situations arises, get the equipment
checked by servicepersonnel:
•The power cord or plug is damaged.
•Liquid has peretrated into the equipment.
•The equipment has been exposed to moisture.
•The equipment does not work well, or you cannot
get it to work according to the user manual.
•The equipment has been dropped and damaged.
•The equipment has obvious signs of breakage.
15. Do NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT
WHERE THE STORAGE TEMPERATURE MAY GO
BELOW -20°C (-4°F) OR ABOVE 70°C (158°F) THIS
COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT
SHOULD BE IN A CONTROLLEDENVIRONMENT.
Startup Manual 2
Rack MountingSafety Instructions
Overview
