AEG DVE5671HR User manual

USER
MANUAL
EN User Manual
Cooker Hood
DVE5671HR
DVE5971HR

CONTENTS
1. SAFETY INFORMATION AND INSTALLATION...................................................2
2. PRODUCT DESCRIPTION...................................................................................3
3. DAILY USE........................................................................................................... 3
4. CARE AND CLEANING........................................................................................ 5
5. ENVIRONMENTAL CONCERNS..........................................................................6
FOR PERFECT RESULTS
Thank you for choosing this AEG product. We have created it to give you
impeccable performance for many years, with innovative technologies that help
make life simpler – features you might not find on ordinary appliances. Please
spend a few minutes reading to get the very best from it.
Visit our website to:
Get usage advice, brochures, trouble shooter, service and repair information:
www.aeg.com/support
Register your product for better service:
www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance:
www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the
following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information
General information and tips
Environmental information
Subject to change without notice.
1. SAFETY INFORMATION AND INSTALLATION
WARNING!
Refer to the separate
Installation Instructions
booklet for Safety
Information and Installation.
Read carefully the Safety
chapters before any use or
maintenance of the
appliance.
www.aeg.com2

2. PRODUCT DESCRIPTION
2.1 Control panel overview
1 2 3 4 5 6 7 8 9
Function Description
1On / Off Turns the hood on and off.
2First speed The motor switches to first speed level.
3Second speed The motor switches to second speed level.
4Third speed The motor switches to third speed level.
5Maximum speed The motor switches to maximum speed level.
6Breeze The hood operates on the lowest speed. After 60 mi‐
nutes the appliance turns off.
7Filter notification Reminds to change or clean the charcoal filter and
clean the grease filter.
8Hob²Hood Indicator of the function to control hood from hob.
9Lamp Turns the lights on and off.
3. DAILY USE
3.1 Using the hood
Check the recommended speed
according to the table below.
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking
zones or burners, gentle frying.
While boiling and frying big quantities of food without
a lid, cooking on multiple cooking zones or burners.
While boiling and frying big quantities of food without
a lid, big humidity.
Refreshes the air in kitchen after cooking at a very
low noise level. It can be activated and de-activated
by touching the symbol. The function turns off auto‐
matically after 60 minutes. Use after cooking only.
ENGLISH 3

It is recommended to leave
the hood operating for
approximately 15 minutes
after cooking.
The control Panel is a
sensor field. Touch the
symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing
the symbol.
You can now activate the functions.
2. To activate the function touch the
symbol.
3. If needed, touch the light symbol
to illuminate the cooking surface.
To turn off the appliance press the
symbol again.
3.2 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
For more information how to
use the function refer to the
hob user manual.
3.3 Activating Maximum
Motor Speed
When you touch , the Maximum
Motor Speed starts to operate for 8
minutes. After that time, the appliance
returns to its previous speed settings.
When the function is turned
on, additional touch on
does not have any effects.
3.4 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter. The filter indicator is turned on
(red) for 30 seconds if the grease filter
must be cleaned. The filter indicator
flashes (red) for 30 seconds if the
charcoal filter must be replaced or
cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
To reset the function touch for 3
seconds.
To activate or deactivate function:
1. Switch on the control panel.
2. Make sure that the icons are turned
white.
3. To activate function touch for 3
seconds.
If the function is activated, the filter icon
flashes (red) five times.
4. To deactivate function touch for 3
seconds.
If the function is deactivated, the filter
icon flashes (red) three times.
www.aeg.com4

4. CARE AND CLEANING
4.1 Notes on cleaning
Cleaning
Agents
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains ap‐
pliance must be cooled down and dried with clean cloth or paper tow‐
els.
Clean stains with a mild detergent.
Keep the hood
clean
Clean the appliance and grease filters each month. Clean the interior
and grease filters carefully from fat. Fat accumulation or other residue
may cause fire.
Follow the instructions for cleaning the accessories when filter notifica‐
tion is on. Refer to Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle.
The grease filter may discolour, it has no influence on the performance
of the appliance.
Charcoal filter
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
4.2 Cleaning the grease filter
Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Pull the cover to open it.
1
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
1
2
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
ENGLISH 5

The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
5. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.3 Replacing the charcoal
filter
The charcoal filter must be replaced if
the filter alarm is on.
Refer to the filter notification
in daily use chapter for more
information about function.
WARNING!
The charcoal filter is NON-
washable! The filter cannot
be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Turn the filter counterclockwise (1)
and then pull (2).
1
2
To mount the filters back follow the steps
in reverse order.
4.4 Replacing the lamp
This appliance is supplied with a LED
lamp and separate control gear (LED
driver). These parts can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
5. ENVIRONMENTAL CONCERNS
Recycle materials with the symbol .
Put the packaging in relevant containers
to recycle it. Help protect the
environment and human health by
recycling waste of electrical and
electronic appliances. Do not dispose of
appliances marked with the symbol
with the household waste. Return the
product to your local recycling facility or
contact your municipal office.
*
www.aeg.com6

www.aeg.com/shop
867351966-A-072023