Agilent Technologies N4376B User manual

Manual Changes Supplement
_____________________________________________________________________________
N4376B Lightwave Component Analyzer
User’s Guide
This supplement is written for the N4376B Lightwave Component Analyzer User’s Guide, part number
4376B-90A02, print date January 2009. It contains important information for correcting manual errors.
Part Number: 5991-3001EN
Print Date: May 2013 ©Agilent Technologies, Inc. 2013

2
Contacting Agilent
Assistance with test and measurement needs and information on finding a local Agilent office are available
on the Web at:
http://www.agilent.com/find/assist
If you do not have access to the Internet, please contact your Agilent field engineer.
In any correspondence or telephone conversation, refer to the Agilent product
by its model number and full serial number. With this information, the Agilent
representative can determine whether your product is still within its warranty
period.

3
_____________________________________________________________________________
Change 1
Change 1, on Page 147, in the specifications table for optical to electrical measurements at 850 nm (OE
mode) shows an instance of “typ” that must be removed.
Instructions
In the “Minimum measurable frequency Response (noise floor)b c ” row of the specification table, remove
“typ.” after “−58 dB (A/W)” as shown below.
_____________________________________________________________________________
Change 2
Change 2, on Page 148, in the specifications table for optical to optical measurements at 850 nm (OO mode)
shows two instances of “typ” that must be removed.
Instructions
In the “Relative frequency response uncertaintya ” row of the specification table, remove “typ.” after “±0.4
dBe” and “±0.5 dBe” as shown below.