AIDA UHD-100 Installation and operation manual

UHD-100 FW Upgrade Guide
Version: 3.28.2019

Page | 2
Disclaimer: Please pay close attention to the
guide, and read all the steps. Only use the
original or a recommended power supply, and
ensure that the update process is not
interrupted at any moment. Failure to follow
these steps may result in irreversible damage to
the camera.
IF you are unsure of a step or how to proceed,
please message our support staff at:
[e-mail]
Or give us a call during our normal business
hours of 8AM-5PM, Monday to Friday (PST.)
We will be more than happy to assist you.
Thank you for choosing AIDA Imaging as
your camera solution!

Page | 3
What you need:
•UHD-100 Camera
•Micro USB Cable
•Windows PC (Mac not supported)
•UHD_FW_UP Software
•Latest Firmware (bin file)
*The UHD_FW_UP software and latest firmware
come in the same file as this guide.
For the most recent firmware, please visit our
download page and check the latest firmware
tab.

Page | 4
Step 1: Software installation
1.Run the file UHD_FW_UP_setup_v0.2 as seen
below.
2.Follow the installation directions.
3. Once installed, the UHD_FW_UP shortcut
icon will be created on the desktop screen.
4.Open the shortcut, and you will see an
interface similar to the picture below.

Page | 5
Step 2: Firmware Update
1. Power on the camera with the original or
recommended power supply. Ensure that
the power does NOT get interrupted during
the updating process.
2.Connect the UHD-X3L to your computer via
the micro USB cable
3.Open the UHD_FW_UP software
4.Select the correct com port on the
interface. If you are unsure, please check
the device manager, under ports as seen
below:

Page | 6
5. After selecting the correct port, press the
open button.
6.Next, click “파일열기.” (Open File.) Then
select the UHD 100 bin file found in the
folder.

Page | 7
7. Lastly, click “시작” (start.) This will begin
the updating phase. *Ensure that no
interruption to the power or cable happens.
8. You know the update is done when you
see this screen. You may now unplug the
micro USB cable.

Page | 8
At this point, you may close the program. If you
want to check if the FW update worked, go to
the OSD menu on the camera and check
system info. The FW number should match the
most recent bin file date you updated.
Again, if you have any questions about this
process, please message our support staff at:
[e-mail]
*The process of updating is the same for our
UHD Camera line-up, and the process will be
the same henceforth unless changed otherwise.