AIDA UHD6G-X12L Installation and operation manual

UHD6G-X12L FW Upgrade Guide
Version: 1.13.20

Page | 2
Disclaimer: Please pay close attention to the
guide, and read all the steps. Only use the
original or a recommended power supply, and
ensure that the update process is not
interrupted at any moment. Failure to follow
these steps may result in irreversible damage to
the camera.
IF you are unsure of a step or how to proceed,
please message our support staff at:
[email protected]
Or give us a call during our normal business
hours of 8AM-5PM, Monday to Friday (PST.)
We will be more than happy to assist you.
Thank you for choosing AIDA Imaging as
your camera solution!

Page | 3
What you need:
UHD6G-X12L Camera
Micro USB Cable
Windows PC (apple not supported)
USB_FW_UP Software
Latest Firmware (bin file)
*The USB_FW_UP software and latest firmware
come in the same file as this guide.
For the most recent firmware, please visit our
download page and check the latest firmware
tab.
If you are unsure of what camera you are
using, please take a look at the serial number
located on the camera. It will give you the
product name.

Page | 4
Step 1: Software installation
1.Run the file USB_FW_UP as seen below.
2.Follow the installation directions.
3. Once installed, the shortcut icon will be
created on the desktop screen.
4.Open the shortcut, and you will see an
interface similar to the picture below.

Page | 5
Step 2: Firmware Update
1. Power on the camera with the original or
recommended power supply. Ensure that
the power does NOT get interrupted during
the updating process.
2.Connect the UHD6G-X12L to your computer
via the micro USB cable
3.Open the USB_FW_UP software
4.Select the correct com port on the
interface. If you are unsure, please check
the device manager, under ports as seen
below:

Page | 6
5. After selecting the correct port, press the
open button.
6.Next, click Browse. Then select the UHD6G-
X12L bin file found in the folder.

Page | 7
7. Lastly, click Start. This will begin the
updating phase. *Ensure that no interruption
to the power or cable happens.
8. You know the update is done when you see
this screen. You may now unplug the micro
USB cable.

Page | 8
At this point, you may close the program. If you
want to check if the FW update worked, go to
the OSD menu on the camera and check
system info. The FW number should match the
most recent bin file date you updated.
Again, if you have any questions about this
process, please message our support staff at:
[email protected]