AirLive VOIP-111A User manual

How to configure VoIP Gateway?
1
There are two modes to configure the VoIP environment: SIP Proxy and Peer
to Peer, you can accord to your actual required to choose the mode to work
on. Please refer the elow for more detail configuration.
SIP Proxy Mode: (Register to SIP Proxy Server)
A SIP VoIP network requires a “SIP proxy server” to act as the central
controller. The est way to use SIP device is either to register with a free
pu lic VoIP server such as FWD / IPtel or to register with a local ITSP
(Internet Telephony Service Provider) in your country.
If you want to use the SIP Proxy Mode, you will need to type your SIP
account into your Device.
※For example:

How to configure VoIP Gateway?
2
So, when you want to dial up
VoIP-111A(A) dial “200 ” to dial to VoIP-111(B)
VoIP-111A(B) dial “100 ” to dial to VoIP-111(A)
Peer to Peer Mode:
A type of network in which each workstation has equivalent capa ilities and
responsi ilities. In VoIP network, to call out to other point is y IP address.
Generally, our VoIP-111A supports the “Phone Book” feature.
For example, so when you dial “1 ” the device should search phone ook, if
search match num er 1 will send out “070000002@192.168.15.210”, if

How to
not got match num er will send out 1.
--------------------------------------------------------------
For single side installation:
Feature1:
How to make a phone call
When your ATA is configured properly, you can make a phone call to your
friend in the same Service provider.

If you want to make a phone call, you can dial the phone num er and
press “ ”
utton to start to dial the phone

If you want to make a PSTN call, you can press “
PSTN line than start to dial the normal phone num er.
Feature2:
The VoIP also provides some function that list as elow:
Call Waiting
: When a new call is coming while you a
push the Flash
utton to switch to the new call. You can push the
Flash
utton to switch etween the two calls.
How to
configure VoIP Gatewa
y
3
not got match num er will send out 1.
--------------------------------------------------------------
For single side installation:
How to make a phone call
When your ATA is configured properly, you can make a phone call to your
friend in the same Service provider.
If you want to make a phone call, you can dial the phone num er and
utton to start to dial the phone
num er.
If you want to make a PSTN call, you can press “
0
” utton to switch to
PSTN line than start to dial the normal phone num er.
The VoIP also provides some function that list as elow:
: When a new call is coming while you a
re talking, you can
utton to switch to the new call. You can push the
utton to switch etween the two calls.
y
?
When your ATA is configured properly, you can make a phone call to your
If you want to make a phone call, you can dial the phone num er and
” utton to switch to
re talking, you can
utton to switch to the new call. You can push the

How to configure VoIP Gateway?
4
Call Hold: You can push the Hold key to hold the current call for a
while, then push Hold key again to keep talking.
3-way conference: If you want to make 3-way conference call, you
can make a phone call to the first phone num er. After the call is
esta lished, push the Flash utton then you can hear the Dial tone,
then make a phone call