Albrecht AE 5090 XL User manual

AE5090 XL MULTI MODE
Power & 400 CH settings
Standard power (4 Watts) and 8-10 Watts high power Modification
Open speaker side cabinet, find the plug-in jumper location on main board between VCO
(shielded part) and RF power amplifier transistors (see photos)
Connect two pins connector left side Multi 01 and 02: 1W AM / 4W FM
Standard delivery Multi 03 : 4W FM
Multi 04 and 05: 4W AM/FM
CPU # 38 or 39 or 40 = L: 4W AM/FM
Connect two pins connector right side Multi 01 and 02: 1W AM / 8W FM
Or open jumper (see photo) Multi 03 : 8W FM
Multi 04 and 05: 8W AM/FM
CPU # 38 or 39 or 40 = L: 8W AM/FM
High power position 8...10 W max
Standard position 4 Watt

Standard Multi Mode (this is the factory default mode:
Press MULTI during switching on
01 = 80/40, FM/AM Germany and CZ
02 = 40/40, FM/AM all countries, FM 4 Watt, AM 1 Watt
03 = 40 FM only
0 4 = 40/40, FM/AM Spain, AM + FM both 4 Watts
05 = 40/40, FM/AM “0" Raster Poland, AM + FM both 4 Watts
Modification for 400 channels
• Switch the radio off
• Disconnect jumper SW1 or whatever was soldered before (SW3 or SW4)
Connect jumper SW2 ( install a 0 ohms resistor or add a solder jumper at SW
2 position at Front PCB )
• Switch on the radio
• Press F button about 1 sec until channel display change to Band (from A to
J)
• Rotate rotary channel switch or press mic up and down while the band display
still blinking to select the desired band.
• The selected band will be set automatically after the band display blink 3 times
and the display is back to previous channel
• In 400 Ch mode no country switching is possible
SW 1 is the standard jumper,
means multi mode enabled