Alphatech FTZ123-D12 User manual

Door Intercom FTZ
Door Intercom FTZ123-D12
User manual

Description
To different PABX (GESKO, TipTel, Agfeo etc..) you can connect
this door intercom byinterface FTZ 123-D12. This door intercom
has been produced in variant 1 or 2 buttons.
Connection ofFTZ systém is by8wires wich are ended by
RJ45. It is neccessarykeep ofwires order!! Installation make
alwayswhen PABX is off the main! For orientation ofwires is
possible use connection oftwosignals „Gnd“, which are
connected throughin PABX. Decreasingofwires number is
possible bydisconnectingof2button „Tl.2“ and second signal
„Gnd“ to 6wires. The nextdecreasingis when you do not want
close el. Lock - wire „Sw.“ It means that min. number ofwires ise
5.
8 pin screrwterminals in door phone is designed for connection to
PABX. (via picture 2).
To door phone is neccessarylead power supplyfor electrical lockand
lightingofcards.
Procedure of acoustic setting:
1. trimrs SPK a MIC turn to end ofright position
2. trimr BAL set without acoustic feedback(you can changepolarity
ofspeaker)
3. bytrimr SPK increase loudness ofspeaker

Obr. 1 Connection of cables to GESKO PABX
Obr. 2 Connecttion FTZ123 made in Alphatech

Alphatech spol. s
r.o.
Jeremenkova 88
140 00 Praha 4
tel. 02 - 721 033 35, fax. 02 - 721 033 34
e-mail: [email protected]
internet: http://www.alphatech.cz
naše sou adnice GPS (WGS 84)
N 50
°
02
′
35.5
″
E 14
°
25
′
42.0
″