Electric Bolt
EB1001
Read all instructions before starting installation
Ensure you have the following:-
- Strike plate
- Electric bolt
All rebate strips and/or frame stops
should be fitted before starting.
A 2 amp Power Supply should be
provided to ensure there is a Full 1
amp for the bolt. This should allow
for a basic Access System and a
back up battery to be connected
to the same source.
WARNING - THE CONNECTION OF
AN INCORRECT VOLTAGE MAY
RESULT IN DAMAGE NOT COVERED
BY THE PRODUCT WARRANTY.
PACK CONTENTS
Technical Information
General Installation Instructions
Power to Lock/Fail open.
Stainless steel bolt - diameter 15mm
- throw 15mm
Voltage required - 12vDC
Activating current - 1.0A
Holding current - 250 mA
Fully protected against transients and
reverse polarity
The Autolock Time Delay can be set for 0,
3, 6 or 9 seconds.
Monitoring - Door position switch (DSS)
- Bolt position indicator
Bolt Face Plate 203 x 34 x 3mm
Strike Plate 98 x 34 x 3mm 15
126.5
203
57.5
9.5
40
14
172
3
AUTOLOCK TIME DELAY SETTING
0 SEC
3 SEC
6 SEC
9 SEC
1 2
ON
OFF
1 2
ON
OFF
1 2
ON
OFF
1 2
ON
OFF
17
9.5
1
2
3
x8
x4
