Electric Mini Bolt
EB501-22
Read all instructions before starting installation
Ensure that
You have the following:
• Strike plate
• Electric bolt
All rebate strips and/or frame stops
should be fitted before starting
A 2 amp Power Supply should be
provided to ensure there is a Full 1 amp
for the bolt. This should allow for a basic
Access System and a back up battery
to be connected to the same source.
WARNING: THE CONNECTION OF AN
INCORRECT VOLTAGE MAY RESULT
IN DAMAGE NOT COVERED BY THE
PRODUCT WARRANTY.
The selection of appropriate power
supply cable is very important to
ensure lock receives sufficient power to
operate.
Connect flying leads (+) Red (-) Black.
Note - other leads for connection of LED
via plug in lead *NOT FOR POWER INPUT*
This product has been designed for use
in weather protected areas and under
normal circumstances does not require
any maintenance. DO NOT OIL OR
LUBRICATE.
This product must be used in
conjunction with a quality floor spring
or door closer to ensure positive
realignment on closing.
PACK CONTENTS
1
2
3
4
5
6
7
GENERAL INSTALLATION INSTRUCTIONS
x8 x4
