Amantii CUBE-2025WM Assembly instructions

CUBE REPAIR GUIDE
CUBE‐2025WM

•How to replace the LED light
•How to replace the flicker motor
•How to replace the heating element
•How to replace the PCB board
•How to replace the signal receiver
•How to replace the Canopy light
TABLE OF CONTENTS

Unscrew the front glass securing steel panel and remove the front
glass panel.
Securing panel locations Unscrew
STEP 1
HOW TO REPLACE THE LED LIGHT
CUBE‐2025WM

Grasp the steel bar and pull it out
Towards you (horizontally as shown). Then pull it upward to take
it off.
STEP 2

Remove the ember bed glass panel,
you will find the ember bed LED light
beneath the glass panel.
Unplug the red circled socket and
replace the LED light.
You can now replace ember bed LED light
Change flame light, see step 4
STEP 3

Replace the flame LED light.
Unscrew the screws circled above to remove the back cover.
STEP 4

When the back cover is removed, you can
replace the LED light circled in red for the
flame.
STEP 5

After you have completed STEP 1 through
STEP 3, you will be here:
Flicker motor for ember bed is located here
REPLACE THE EMBER BED FLICKER MOTOR

Disconnect the flicker rod
connected to the ember
bed flicker motor.
Unscrew and remove
the ember bed flicker motor.
Unplug the ember bed
flicker motor and
replace with a new
ember bed flicker motor.
REPLACE THE EMBER BED FLICKER MOTOR
STEP 1

Flicker motor for ember bed
is located here
REPLACE THE FLAME FLICKER MOTOR
Unscrew the screws circled in red and remove the back cover.