Amantii Symmetry XT 3.0 Series Assembly instructions

Repair Guide for
Symmetry XT 3.0 Series
Version 1 – 03.01.22

Content
•Replacing the LED light
•Replacing the flicker motor
•Replacing the heating element
•Replacing the PCB board
•Replacing the signal receiver
•Replacing the canopy light
•Replacing the touch panel
•Replacing the Wi-Fi card

Replacing the LED Tray Lights
Step 1 To remove the trim, remove the screws circled in red

Magnetic stone
Trim
Note that there are magnetic stones securing the bottom of the trim to the fireplace

Step 2 After the trim’s been removed, remove the front glass panel.
Front glass panel

Step 3 Remove the steel panels holding the glass tray by removing the screws
circled in red
The steel panels

Step 4
To remove the tray glass panel, lift one end upwards.

The tray lights are below the glass panel.

Step 5
A new LED strip can be installed by unbuckling the hooks that hold the failed one,
unplugging and replacing it
Unplug
Unbuckle

Replacing the LED flame light
You arrive here after following Steps 1 to 4 in Replacing the LED Tray Lights
Step 1 The steel bar fixing the back glass must be removed by unscrewing
the screws circled in red. The back glass can then be removed

Zoomed View Zoomed View
Step 2
Simply undo the screws circled in red
remove the flame stencil

HOOK
BUCKLE
The defective LED strip must be removed from the hooks and the buckle
must be unplugged to replace it
Step 3

Replacing the flicker motor
You arrive here after following Step 1 to 4 in Replacing the LED Tray Lights.

Zoomed View Zoomed View
Step 2
Simply undo the screws circled in red to
remove the flame stencil

On the left side is the flame motor that appears after the flame stencil has
been removed.

Remove the screw Disconnect the
motor from the rod
Remove the screws
to take off the motor
Step 3

Remove the inner top panel by unscrewing the screws circled in red.
Step 4

INNER TOP PANEL
Pull down the inner top panel.
Step 5

Unplug the flicker motor from the circuit board and replace it with a new one.
Step 5

mounting .
Replace the heating element
You arrive here after following Step 1 to 4 in Replacing the LED Tray Lights.