Amart Furniture KYSON 77490 User manual

ASSEMBLY INSTRUCTION
KYSON 2.5ERER
ITEM CODE 77490/77617
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
1
102cm
206cm
Depth: 98cm
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
15
2
2
WARNING
•Do Not allow children to play on this mechanised furniture or
operate the mechanism. Leg rest folds down on closing so that
a child could possibly be injured. Always leave in an upright and
closed position. Keep hands and feet clear of mechanism. Only
the occupant should operate it.

Step1: Locate the recliner power pack which is fixed on the mechanism at
the bottom of left hand facing recliner.
Step2: Keep back rest in an upright position then slide receivers into steel
mechanism posts at seat of the left hand facing recliner, Press both sides of
the back firmly into place to ensure it is fully locked.
3
Power Pack
Transformer cable
1pcs
Transformer Power cable
1pcs
1pcs
Power Parts Connection
Transformer
Transformer cable
Power cable
Receiver at bottom
of back rest
slide receiver
into post
Mechanism post
at rear of seat

Step3: Connect the cords ‘A’ and ‘B’ for power connection between headrest
and seat. One cord comes from the back and the other from the seat of the
left hand facing recliner.
Step4: Keep back rest in an upright position then slide receivers into steel
mechanism posts at seat of the right hand facing recliner, Press both sides of
the back firmly into place to ensure it is fully locked.
4
A
B
slide receiver
into post
Receiver at bottom
of back rest
Mechanism post
at rear of seat

Step5: Connect the cords ‘A’ and ‘B’ for power connection between
headrest and seat. One cord comes from the back and the other from the
seat of the right hand facing recliner.
Step6: Connect the right hand facing recliner to the left hand facing
recliner. Slide clips together then press the front and rear sides to ensure
the clips are connected all the way to the bottom.
5
A
B

Step7: At the rear and base of lounge, connect the cords between the
left hand facing recliner and the right hand facing recliner for electric
reclining motion of the left and right recliners.
Step8: Plug power parts connection (refer to step 1) into socket
at back panel of left hand facing recliner.
6
SAFETY NOTE:
PLEASE ENSURE THAT ALL ELECTRICAL CORDS AND CABLES ARE CLEAR
OF THE FRAME AND MECHANISM. A FAILURE TO DO SO MAY SEVER
YOUR POWER CORD RESULTING IN SERIOUS INJURY OR DEATH.

YES NO
7

8