Amart Furniture 65873 User manual

LIONEL 3 SEATER
ITEM CODE - 65873
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please
phone Amart Furniture, Customer Service Free call 1800 351 084
PAGE 1 OF 5 65873
ASSEMBLY INSTRUCTION
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone Amart
Furniture, Customer Service Free call 1800 351 084

BEFORE YOU START…
1. CHOOSE A CLEAN, LEVEL, SPACIOUS ASSEMBLY AREA. AVOID HARD SURFACES THAT MAY DAMAGE
THE PRODUCT.
2. TAKE CARE WHEN LIFTING. PRODUCT SHOULD BE ASSEMBLED AS NEAR AS POSSIBLE TO THE POINT OF USE.
3. CHECK AND ENSURE THAT YOU HAVE ALL THE REQUIRED CONTENTS FOR COMPLETE ASSEMBLY.
4. ALWAYS READ THE ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE BEGINNING ASSEMBLY.
5. THE PACKAGING AND CONTENTS CAN BE CHOCKING HAZARDS, THEREFORE KEEP OUT OF REACH OF
SMALL CHIDREN AT ALL TIMES.
6. DO NOT OVER TIGHTEN THE SCREWS AND BOLTS AS THIS MAY DAMAGE THE THREADS.
PAGE 2 OF 5 65873
PRE-ASSEMBLY PREPARATION

PLEASE TAKE NOTE: PIECES REQUIRE FOR ASSEMBLY ARE LOCATED INSIDE THE DUST COVER
UNDERNEATH SOFA
PAGE 3 OF 5 65873
PARTS LIST
Hardware List
LEG
8 PCS
4 PCS
1 PC
E
PLASTIC WASHER
SUPPORT LEG
D1 PC
ALLEN KEY M5
C1 PC
M8 x 25mm
B
A

DETAILS (i) - Align base plate of each foot (A) with the pre-threaded holes in the undersides of
the sofa as shown in the below diagram. Insert Bolt (B) and tighten by turning clockwise using
Allen key (D)
DETAILS (ii) - Align base plate of each foot (D) with the pre-threaded holes in the undersides of
the sofa as shown in the below diagram. Insert leg (E) and tighten by turning clockwise using hand.
STEP2 ASSEMBLY COMPLETED
PAGE 4 OF 5 65873
Step 1
IMPORTANT: PLEASE ENSURE FEET ARE TIGHTENED SECURELY BEFORE USE!
WARNING - Do not drag lounge on any surface due to timber base, must be lifted.
Two Person Lift Recommended
A
B
D
C
E
'ii'
'i'
'i'
'i'
'i'
LEG AT BOTTOM
OF THE SOFA

LEATHER CARE (FRAME)
WHEN NECESSARY BRUSH OR VACUUM AWAY
DUST AND GRIT. WIPE OVER WITH A SOFT, CLEAN,
DYEFAST CLOTH.
FOR SPOTS AND SPILLS:
WIPE EXCESS LIQUID UP IMMEDIATELY WITH AN
ABSORBANT CLOTH OR SPONGE.
FOR OVERALL CLEANING:
WE RECOMMEND CLEANING EVERY 3-4 MONTHS
WITH
∙ LEATHER CLEANER FOLLOWED BY
APPLICATIONS OF
∙ LEATHER PROTECTOR.
ALWAYS FOLLOW DIRECTIONS ON PACKS.
NOTES:
ACCUMULATION OF PERSPIRATION AND BODY
OILS ON ARMPADS, HEADREST ECT. MAY
DAMAGE YOUR LEATHER - THESE AREAS MAY
REQUIRE MORE FREQUENT CLEANING.
DO NOT EXPOSE LEATHER TO DIRECT SUNLIGHT;
INTENSIVE HEAT; WEATHER; OR SOAK
UNNECESSARILY. ALWAYS AVOID EXCESSIVE HARD
RUBBING.
DO NOT DRY CLEAN OR MACHINE WASH.
DO NOT USE SADDLE SOAP; DETERGENTS;
SOLVENTS; ABRASIVES; UNIDENTIFIED LEATHER
CLEANERS; SUEDE CLEANERS OR ANY PRODUCTS
CONTAINING SILICON OR SOLVENTS.
PAGE 5 OF 5 65873
CARE AND MAINTENANCE