American Standard Green Tea Whirlpool and Bathing Pool... User manual

H1
GREEN TEA™ 5' x 36"
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
GREEN TEA™ 5' X 36" WHIRLPOOL
❏3571.018WC Whirlpool featuring System I
• Acrylic with berglass reinforcement
• Pre-leveled tub bottom
• Form-tted backrest position
• Raised neck support
• Dual, molded in arm rests
• 1.4 HP single speed, self-draining pump/motor
• Factory installed power cord with plug
• Eight multi-directional and ow-adjustable jets
• Side-mounted air switch On/Off
• Can be under-mount installed
• Two silent air volume controls
• Quick Connect Safe-T-Heater
connection system
• Factory installed and tested whirlpool system
• EverClean™ whirlpool system
❏3571.002 Bathing Pool
• Same as above without whirlpool system
Nominal Dimensions:
1524 x 914 x 533mm
(60" x 36" x 21")
Compliance Certications -
Meets or Exceeds the Following Specications:
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
The EverClean™ system incorporates AlphaSan®, a
patented antimicrobial agent manufactured right into
the circulation system components, which suppresses
the growth of unsightly algae, fungus, mold and mil-
dew.
SEE REVERSE FOR ROUGHING-IN DIMENSIONS
AND PRODUCT SPECIFICATIONS
To Be Specied - Required:
❏Color:
❏Bath Filler: (specify nish)
❏Bath Drain: 1583.470 (specify nish)
To Be Specied - Optional:
❏Safe-T-Heater*: 9075.120
❏Jet Trim Ring Kit: 9860.200-two per kit (Specify nish)
for Body Massage Jets only
❏Universal Tile Bead Kit: 751755-100
For color/nish availability and other faucet choices, please
see the Product Selector and Pricing Guide.
* NOTE: the Safe-T-Heater is designed to maintain water
temperature during operation. It will not heat cold water to
desired bathing temperature.
Rev. 11/07
© 2007 American Standard Inc.
AlphaSan is a registered trademark of Milliken & Co.

H2
© 2007 American Standard Inc.
GREEN TEA™ 5' x 36"
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
Rev. 11/07
60
(1524mm)
36
(914mm)
11-1/2
(292mm)
OUTLINE OF CUTOUT 58.5 x 34.5 (1486 x 876mm)
14-3/4
(375mm)
ON/OFF
SWITCH
PUMP
(2) AIR VALVES
CUTOUT IN FLOOR FOR DRAIN
9
(229mm) C
L
19
(483mm)
21
(533mm)
INTEGRAL FEET
ROUGH
FLOOR
4
(102mm)
2
(51mm)
C/L OF OVERFLOW
SAFE-T-HEATER
REMOVABLE
BLANK
LEVELING STRINGER NOT
FOR SUPPORT
PROVIDE ACCESS TO PUMP FOR
SERVICE ON ALL INSTALLATIONS
60 x 36 x 21 In. (1524 x 914 x 533mm)
86 Lbs. (39 Kg.)
519 Lbs. (235 Kg.)
52 Gal. (197 L.)
38 Gal. (144 L.)
19 x 43 In. (483mm x 1092mm)
48-1/2 x 27 In. (1232mm x 686mm)
14 In. (356mm)
35 Lbs./Sq. Ft. (169 Kgs/Sq. m.)
23.8
44.5
GENERAL SPECIFICATIONS FOR 3571 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
MIN. OPERATING GAL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
1.4 HP, 7.5 AMPS, 120V.SYSTEM I PUMP
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP OF
BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL 3 WALL TILING BEAD. KIT AND APRON NO. 9260.018 OR 9360.018 AVAILABLE AND MUST BE ORDERED SEPARATELY.
● FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
● IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING
SYSTEM PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.
60 x 36 x 21 In. (1524 x 914 x 533mm)
54 Lbs. (24 Kg.)
487 Lbs. (221 Kg.)
52 Gal. (197 L.)
19 x 43 In. (483mm x 1092mm)
48-1/2 x 27 In. (1232mm x 686mm)
14 In. (356mm)
32 Lbs./Sq. Ft. (159 Kgs/Sq. m.)
23.8
44.5
GENERAL SPECIFICATIONS FOR 3571 BATHING POOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
60
(1524mm)
36
(914mm)
11-1/2
(292mm)
OUTLINE OF CUTOUT 58.5 x 34.5 (1486 x 876mm)
14-3/4
(375mm)
CUTOUT IN FLOOR FOR DRAIN
9
(229mm) C
L
19
(483mm)
21
(533mm)
INTEGRAL FEET
ROUGH
FLOOR
4
(102mm)
2
(51mm)
C/L OF OVERFLOW
LEVELING STRINGER NOT
FOR SUPPORT