American Standard Standard Collection Pedestal Sink 0283.800 Operating and safety instructions

J7
© 2008 AS America Inc.
Standard Collection®
PEDESTAL SINK
FIRE CLAY
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
20
(508mm)
28-1/2
(724mm)
*24
(610mm)
13
(330mm)
*22
(559mm)
36
(914mm)
10-1/4
(260mm)
3-7/8
(98mm)
3/4
(19mm)
6-3/4
(171mm)
7-1/2
(191mm)
FINISHED
FLOOR
SUPPLIES AS
REQUIRED
3/8" DIA.
HOLES FOR
ANCHOR BOLTS
3/8" DIA.
BASE ANCHOR
SCREW HOLE
1-3/4" DIA.
STD. DRAIN
OUTLET
1-1/4 O.D.
WASTE
1-1/4 O.D.
TAILPIECE
PEDESTAL
SIDE SECTION
13
(330mm)
26-3/4
(680mm)
8
(203mm)
8 (203mm)
DRAIN
CHASE
OPEN
TO
FLOOR
To Be Specied:
❏ Color: ❏ White ❏ Linen
❏ Recommended Faucet: 8" spread No. 2881
❏ Faucet Finish: Chrome or Satin
❏ Supplies:
❏ 1-1/4" Trap:
Standard Collection®PEDESTAL SINK
• Authentically styled circa “1922” oval pedestal
• Made from ne reclay
• Front overow
• Supplied with mounting kit
• Design matched to Standard Collection® xtures
• Right Height™ for greater comfort
• Recommended design matched 8" spread faucet
#2881 available in chrome or satin nish
❏ 0283.800 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
26-3/4" x 20" x 36"
(679 x 508 x 914mm)
Separate Components:
❏ 0283.008 Pedestal top 8" (203mm) centers
❏ 0067.000 Pedestal only
Bowl sizes:
16-3/4" (425mm) wide
11-1/4" (286mm) front to back
6-1/4" (159mm) deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.9M for Non-Vitreous
Ceramic Fixtures
• CAN/CSA B45 Series
Revised 2/08