MOUNTING USING EXPANSION CLIPS
(SHOWN THIS SIDE ONLY
FOR THE BB-CP4 FOR SPECIFIC
MOUNTING / MILLWORK SPECIFICATION
AXD-CP4
SP-5921-01
SP-5921-01
A
FULL
1 OF 1
SCALE DWG. NO.SIZE
C
SHEET
REL APPR
INFORMATION.
MOUNTING DIMENSIONS AND
JSV 6/25/01
REL DATE REV APPR
TM
REV.
TO THE MOUNTING SPECIFICATION
CONDUIT WALLBOX. REFER
ACCOMMODATE THE BB-CP4
THIS CUTOUT WILL NOT
NOTICE
ARELEASE TO PRODUCTION 09-21-01
APPROVED
REVISIONS
REV ECN DESCRIPTION DATE
QUALITY
PROJECTION
THIRD ANGLE
ENGINEER
MATL SUP
PROD ENGR
DRAWN
ENGR SERV
ANGLES: +/- 1.0°
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
ALL DIMENSIONS IN INCHES.
TOLERANCE ON HOLE DIAMETERS:
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
UNLESS OTHERWISE SPECIFIED:
DO NOT SCALE THIS DRAWING.
reproduced, or used as the basis
written permission.
for manufacture or sale without
All information contained herein
This drawing may not be copied,
has been previously established.
to the extent the information
shall be confidential except
that is not generally known
property of AMX Corporation.
NOTICE: This drawing is the
OVER .500
.250 TO .500
UNDER .250 ú = +/- .005
= +.008 -.005
= +.006 -.005
XXX = .005
IN THESE 4 CORNERS
.250 MAX RADIUS ALLOWED
IN CORNERS OF NOTCHES
.125 MAX RADIUS ALLOWED
SURFACE (PODIUM, DESK, ETC.).
THREADED INSERTS AT THESE 4
SUGGEST INSTALLATION OF #4-40
SECURE UNIT WITH #4 SCREWS.
LOCATIONS.
WHEN MOUNTING UNIT TO A SOLID
THESE 4 HOLES ARE ONLY REQUIRED
DRYWALL EXPANSIONS CLIPS
IF UNIT IS INSTALLED USING
THESE NOTCHES ARE ONLY NEEDED
(2 PROVIDED)
MOUNTING USING #4 SCREWS
(SHOWN THIS SIDE ONLY)
CUTOUT
FRONT BEZEL
FRONT BEZEL
