Andersen A2 User manual

Basic Solar Charging 
Smart Energy Management

This is installed around the live mains input supply, close to the domestic energy
meter (Fig:1).
A twisted pair shielded signal cable should be used to connect the CT clamp to the
Andersen chargepoint (Fig:2). The cable length between the CT clamp and
chargepoint should not exceed 30 meters.
This can be purchased from Andersen EV.
This CT clamp is specifically calibrated for use with the A2 unit.



 f  (  x  )  b 
 ff  and f 
Andersen EV Solar Charge
Installation Guide
AEV-SC-05052020-IST 1.1-UK

1
Arrow on CT clamp should face
away from meter and towards
all loads i.e. fuse board.
Wiring- White to terminal 3 and
black to terminal 4.
Confirm configuration using the
CT Test in the installer toolbox.
1 2 3 4 5
1 2 3 4 5

Test Procedure-- Using the CT test in the installer toolbox, compare the
value shown to a clamp meter on the supply. Should you suspect solar
surplus, turn off the solar supply and compare again.
The CT test should now show Configuration appears correct.