&Tradition Bellevue AJ10 User manual

Congratulations on your new Bellevue lamp designed
in 1929 by Arne Jacobsen. We hope you will enjoy
using this product and follow these instructions to
ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by
mail on:
in[email protected]
Bellevue AJ10
Arne Jacobsen
1929
Instructions

A
B
03/21
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
ALamp
B Bottom plate for fixation
Tools needed
- Bulb type E14
- Electric drill
- Wrench
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children’s reach.
- The lamp is only intended for interior use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere there is a risk of falling over it.
- If the external cable or cord of this lamp is damaged,
it must be replaced by the manufacture or a similar
qualified person in order to avoid a hazard.
Cleaning instructions
- Wipe surface of lamp shade with a soft, damp spong or
cloth, and wipe immediately after with a dry cloth.
- Do not use any abrasive cleaning tools such as steel
wool, scouring sponges or stiff brushes.
- Never use strong cleaning agents such as white spirit,
terpentine household glass cleaner or cellulose thinners.
- Only wipe the inside of the shade with a soft, damp cloth
or feather duster.
Step 1
Identify the desired location for the lamp on the table top
and mark the middle using a pencil. Next, drill a hole using
a hole drill. The hole should be 50mm in diameter for a CE
plug, and 20mm without CE plug.
Step 2
Place the lamp (A) in the drilled hole. Be sure to place
the cord in first.
Step 3
Slide the bottom plate (B) around the bolt, beneath the
table top but above the washers.
For indoor use only
E14 maximum 25W
Bulb not included
Bellevue AJ10
Arne Jacobsen
1929

Step 4
Tighten the nut by turning it in a counter-clockwise
direction, using a wrench.
Step 5
Install the light bulb.
Step 6
Use the flexible swan-neck to set the shade at a desired
angle. It is best to set the angle before turning on the lamp
as the shade gets hot when the lamp is in use for longer
periods at a time.
andtradition.com