&Tradition Blown SW6 User manual

Congratulations with your new Blown lamp, designed
in 2019 by Samuel Wilkinson. We hope you will enjoy
using this product and follow these instructions to
ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by
mail on:
in[email protected]
Blown SW6
by Samuel Wilkinson
2019
Instructions

A
B
Blown SW6
By Samuel Wilkinson
2019
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
AGlass shade
B Marble base and glass holder
Tools needed
- Bulb type E14
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children’s reach.
- The lamp is only intended for interior use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere there is a risk of falling over it.
- If the external cable or cord of this lamp is damaged,
it must be replaced by the manufacture or a similar
qualified person in order to avoid a hazard.
Cleaning instructions
Glass shade
- Wipe surface of the glass shade with a soft, damp sponge
or cloth, and wipe immediately after with a dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or sti brushes.
Marble base
- The marble base is made from natural marble and will
therefore have variations in structure and colour. This should
not be considered a defect nor a valid reason for claims.
- For daily cleaning of the marble base it is recommended
to use a cleaning agent specifically developed for stone
or marble.
Step 1
The lamp base will be delivered with an attached glass
holder. To install the glass shade, untighten the holder and
lift it from the base.
Step 2
Carefully lower the glass shade onto the base.
Step 3
Lower the holder into the shade and fasten clockwise.
Install the light bulb and insert the plug into a wall socket.
The light is now ready to use. The light intensity can be
adjusted by rotating the dimmer knob on the lamp base.
For indoor use only
E14 maximum 40W
Bulb not included 03/21

andtradition.com