&Tradition Pivot ATD7 User manual

Congratulations on your new Pivot lamp, designed in 2023 by &Tradition. We hope that you
will enjoy using this product. Please follow these instructions to ensure correct installation. If
you have any questions or comments, please do not hesitate to contact us by mail at:
in[email protected]
Pivot ATD7
&Tradition
2023
Instructions

PU
L
L
A
B
PivotATD7
&Tradition
2023
C
D
Please read these instructions carefully and keep them
for future reference to ensure the product is used
correctly. For your own safety, please read each step
of this instruction manual before using the product.
&Tradition is not responsible for any faults or damage
caused by not following these instructions correctly.
Do not modify this product in any way.
Contents
ALamp shade
B Lamp base with battery compartment
C LED G4 3W light bulb
D Magnetic USB cable
Tools needed
- Screwdriver (for replacing batteries)
Safety precautions
- Dispose of plastic bag from packaging immediately
and keep out of reach of children.
- This lamp is for indoor use only. It can be taken outdoors,
but must be kept and stored inside.
- Do not place the USB cable within reach of small children
or anywhere there is a risk of it becoming a trip hazard.
- Batteries must be disposed of according to local
environmental laws for waste disposal.
- Consult a professionally qualified electrician if in any doubt.
- Keep product out of reach of children.
Cleaning instructions
- Wipe surface of the shade with a dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or sti brushes.
- Never use strong cleaning agents such as white spirit,
turpentine, household glass cleaner or cellulose thinners.
&Tradition will not accept any responsibility for any
accidents or injuries that occur due to incorrect USB cable
input. The battery must be removed from the light before
it is scrapped; the appliance must be disconnected from the
supply mains when removing the battery; the battery must
be disposed of safely.
For further information or inquiries, please do not hesitate
to contact &Tradition by mail on [email protected].
Step 1
Remove plastic slip to activate the battery. You do not need
to open the battery compartment.
Step 2
Insert the LED light bulb.
Carefully lower the shade onto the base and turn
clockwise to install.
Step 3
Before use, the battery in the lamp needs to be charged.
Plug the magnetic USB cable into the bottom of the base
and connect the USB cable to a power supply.
For indoor use
Input 5.0V 1A cable
G4 Max 3 Watt dimmable LED bulb
2 × Rechargeable &Tradition batteries
Charging time: 11 hours
Operating time on highest setting: 17 hours 09/22

Step 1
To replace the batteries, start by removing the pad
underneath and unscrew the four screws. Remove the
battery compartment from the lamp exterior.
Step 2
Unscrew the screw in the battery compartment by turning
anticlockwise and remove the lid.
Step 3
Take out the batteries and replace it with new batteries.
Correctly place the batteries by turning the plus and minus
pole as stated in the battery compartment.
Be sure to mount the lid gently by not overturning
the screw in the threading.
Remember to only use ocial rechargeable batteries from
&Tradition.
Replacing batteries
andtradition.com