&Tradition Raku SH8 User manual

Congratulations on your new Raku lamp, designed in 2022 by Sebastian Herkner. We hope
you will enjoy using this product. Please follow these instructions to ensurecorrect installation.
If you have any questions or comments, please do not hesitate to contact us by mail at:
in[email protected]
Raku SH8
Sebastian Herkner
2022
Instructions

A
B
Raku SH8
Sebastian Herkner
2022
C
D
E
PULL
PULL
Please read these instructions carefully and keep them for
future reference to ensure the product is used correctly.
For your own safety, please read each step of this instruc-
tion manual first. &Tradition is not responsible for any
faults or damage caused by not following these instructions
correctly. Do not modify this product in any way.
Contents
ALamp shade
B Lamp base
C Battery compartment (incl. 1 battery)
D LED G4 1W light bulb
E Magnetic USB charging cable
Tools needed
Screwdriver (for battery replacement)
Safety precautions
- Dispose of plastic bag from packaging immediately
and keep out of reach of children.
- This lamp is only intended for indoor use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the USB cable within reach of small
children or anywhere where there is a danger of it
becoming a trip hazard.
- Keep product out of reach of children.
Cleaning instructions
- Wipe surface of the shade with a dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or sti brushes.
- Never use strong cleaning agents such as white spirit,
turpentine, household glass cleaner or cellulose thinners.
&Tradition will not accept any responsibility for any
accidents or injuries that occur due to the use of incorrect
USB cable input. The battery must be removed from
the lamp before it is disposed of; the appliance must be
disconnected from the supply mains when removing
the battery; the battery must be disposed of safely.
For further information or inquiries, please do not hesitate
to contact &Tradition by mail at: [email protected].
For indoor use only
Input 5.0V 1A USB cable
G4 Max 1.5 Watt dimmable LED bulb
1 × Rechargeable &Tradition battery
Charging time
1 battery: 3.5 hours
2 batteries: 6 hours
Operating time on highest setting
1W LED light bulb 1 battery: 11 hours
2 batteries: 20 hours
Step 1
Remove plastic slip to activate the battery by pulling
the slip out from the compartment.
Step 2
Insert the LED light bulb.
Carefully lower the shade onto the base and turn
clockwise to install it.
Make sure the groove in the battery compartment
is aligned with the same groove in the base.
Step 3
Before use, the battery in the lamp needs to be charged.
Plug the magnetic USB cable into the magnetic bottom
of the base and connect the USB cable to a power supply.
09/22

Replacing battery
Step 1
To replace the battery, start by detaching the shade
by turning it counter clockwise. Take out the LED light
bulb. Gently press on top of the socket until the battery
compartment pops out of the bottom.
Step 2
Unscrew the screw in the battery compartment by turning
counter clockwise and remove the lid.
Step 3
Take out the battery and replace it with a new battery.
To correctly place the battery, turn the plus and minus
pole as stated in the battery compartment.
Take caution to mount the lid gently by not overturning
the screw in the threading.
Remember to only use ocial rechargeable batteries
from &Tradition. If desired, two batteries can be installed
to achieve longer operation time.
For further information or for any inquiries, please
do not hesitate to contact &Tradition by mail at
[email protected].
andtradition.com